Breezeblock
-
Posts
2,312 -
Joined
-
Last visited
Content Type
Profiles
Forums
Classifieds
Tip Site Directory
Blogs
Articles
News
Arborist Reviews
Arbtalk Knot Guide
Gallery
Store
Freelancers directory
Everything posted by Breezeblock
-
until you can't file any more
-
560 nuff said buy it you won't regret it
-
how many pairs of teeth?
-
mmm new project on the horizon
-
id agree with that facts and figures before throwing money away
-
as long as the pumps not sucking air i would dodge along with its own tank or can you piggy back a tank at the same level with a big feed hose
-
that sound like not a bad deal i would buy it and do a bit of repairs at a time when you can afford it i don't know if its bushes or just steel on steel in the pivots but they are quite a simple machine have you got a picture to see it
-
i would like to see that can you get a pic up
-
that sounds like a top piece of kit
-
at this time of the year do any of you not chip your holly trees but in stead sell them to florists whats the going rate
-
i done a conversion for allison enterprises last year it was a terex pt80 which is a big skid steer about 5-6 ton and the post knocker was a bryce off a tractor it was a serious piece of kit amazing at how quick it could rattle a strainer in and it was also converted to electric controls but it still need 2 people to do the job which was the only downside but very effective non the less
-
if you fit a lower pressure valve you will need to fit a non return valve in the feed line or it will dump thru the lower pressure side prv
-
ingenious i like that
-
i made a tool that screws on the worm gear and you can just wind it off i think it was for my brother in laws husky 45
-
look out for sloppy pivots and make sure it drives try and drive it up a steep bank to check motors run up the cutter wheel at various rpm for imbalance and bearing wear get a look at the belts if you can
-
sounds silly you can lift 20 tonne of steelwork but you can't lift a 12 stone bloke
-
nope definitely was a dud coil
-
yep it was fixed brought it up the road and it was a faulty coil i had honda coil stuck that on and he ordered a proper one for it later
-
that looks like a good job i like the idea of getting lifted into the crown
-
yep easy big boots and cover both pedals
-
don't use stainless steel for chipper blades the tensile strength is far too low try your local cat dealer they have a hardware catalogue you might get some in there
-
he had a stack of them ours recently pegged it but is currently getting 288 barrel and piston great old saws
-
haha cock
-
bet that made a thump when it landed
-
home baked cake tastes so much better than factory made poop especially with a big mug of t
