Post your stump grinding photos

[Stefan Palokangas]

Thing broke, welded on 10mm plate.
New wheel on the machine

Big stumps



Storm job, and a Scottish Pine taken down due to kids bedroom next to it
Looked dodgy in the wind so took it down.

[daveatdave]

4 hours ago, Stefan Palokangas said:

Thing broke, welded on 10mm plate.
New wheel on the machine

Big stumps



Storm job, and a Scottish Pine taken down due to kids bedroom next to it
Looked dodgy in the wind so took it down.

strange extension on the roof next to a chimney pot and not far off a gas flue  

[openspaceman]

8 hours ago, daveatdave said:

strange extension on the roof next to a chimney pot and not far off a gas flue  

Belvedere, is it a point house by the sea?

[Gray git]

Zt drive shaft snapped
New one is definitely built different with a much more gradual taper

[Hodge]

I love my SG with the Razor wheel, far better than Greenteeth....

[Gray git]

I love my SG with the Razor wheel, far better than Greenteeth....

I bet it is a lot better, looked at retrofitting one to ours and probably will eventually.

[Stefan Palokangas]

I bet it is a lot better, looked at retrofitting one to ours and probably will eventually.

New grinder?

[Stefan Palokangas]

Tight today

[william127]

Not much grinding but I did use it to take a few roots off. Windblown eucalyptus, too big(height above the ground mainly) to do with my hyundai and there's no way to get anything else in so I broke it down with a saw, wedges and a jack. 

It would have been nice to have a bit of help but after chains(couple of old ones to bin, couple needing a big sharpen) petrol and diesel, I'll be £500 up for the day, can't really grumble at that👌👌

[openspaceman]

12 minutes ago, william127 said:

Not much grinding but I did use it to take a few roots off. Windblown eucalyptus, too big(height above the ground mainly) to do with my hyundai and there's no way to get anything else in so I broke it down with a saw, wedges and a jack. 

It would have been nice to have a bit of help but after chains(couple of old ones to bin, couple needing a big sharpen) petrol and diesel, I'll be £500 up for the day, can't really grumble at that👌👌

I know what you mean but given a bit of time

 

 

 

I felt like that 50s song "High Hopes" when I started but it only put 2.3 machine hours on the clock.

 

There looks like scope to get this type of grinder 100mm narrower to get it through a narrow door.