Jump to content

Log in or register to remove this advert

Why is it so wet ?


kev7937
 Share

Recommended Posts

Best way I have found to season is covered top and open sides with mesh like they put round barns to break the wind. The rain hits it and runs down but still allows wind through. I put some bags of logs in a container last year and they came out same moisture as they went in.

Link to comment
Share on other sites

Log in or register to remove this advert

  • Replies 22
  • Created
  • Last Reply

Top Posters In This Topic

Surely the humidity in the garage should be the same as outside though, admittedly the garage can get a tad damp but the store outside isnt the best and is tucked away between the house and garage with two solid walls.

 

Sadly not, as the air in the garage isn't getting changed as fast as the air outside. As damp that creeps in through the walls/floor/roof/windows/door etc. evaporates the RH goes up. As the logs dry the RH goes up. Outside that air is changed for fresh. Inside, it just slows the seasoning right down.

 

Hence it's usually ok to put well-seasoned wood in the garage (as many do) as long as it's not there too long. But it's an awful place to season wood!

Link to comment
Share on other sites

even when split, its still a pain to keep any firewood dry, if you only have out door premisis! even when split! Royal pita!! :thumbdown:

 

Not all fire woods, beech, ash, sycamore etc are easy to dry and stay dry once dried, hence there reputation as good fire woods.

Link to comment
Share on other sites

Sadly not, as the air in the garage isn't getting changed as fast as the air outside. As damp that creeps in through the walls/floor/roof/windows/door etc. evaporates the RH goes up. As the logs dry the RH goes up. Outside that air is changed for fresh. Inside, it just slows the seasoning right down.

 

Hence it's usually ok to put well-seasoned wood in the garage (as many do) as long as it's not there too long. But it's an awful place to season wood!

 

Makes sense, though I'm surprised it can go up by as much as 10%, guess I'll have to build a bigger store down the bottom of the garden.

 

Ta

 

 

Sent from my iPhone using Tapatalk

Link to comment
Share on other sites

Not all species of wood will read the same for a given moisture content. I have a fairly old but expensive moisture meter that came with a set of tables to correct from the given reading. The variation can be as much as 5% different from the given reading ie it reads as 20% and is actualy 25% or vice versa. Sadley I have lost this set of tables so can't help with specific speicies other than oak and ash do not need any correction.

Link to comment
Share on other sites

Due to this wet weather problem that is not going away this winter problem I have been experimenting with my showroom stove burning wood up to about 35%. Essentially keep the secondary air ( the air wash) fully open and leave it alone, control the fire using the primary air supply under the grate. It takes a while to get a good hot bed but once you do as long as you dont let the fire burn down to far between fills then you are away. My stove ( a Morso) then runs at its usual temperature.

 

You wont get the same heat that you would from 16% stuff agreed but it can be persuaded to burn reasonably acceptably.

 

A

Link to comment
Share on other sites

We had good results using IBC cages to dry wood, they're roughly a cube, well ventilated, stack well as long as you don't bend them too much with the tractor and when empty I can carry them about.

 

Just used to chuck a rigid plastic sheet over the top.

a bit of rain onto the sides doesn't seem to hinder drying at all.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share


  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.