346xp bigger bar?

[Gerbutt]

Hiya

 

is it possible to get a bigger bar than an 18 inch for a 346xp?

[Stubby]

It is possible as I have seen a 20" .325 in the past but I would not recommend it  > I run a 15" driven with an 8 pin sprocket on my Spud ported one .

[Ferguson system]

20" bar is the limit on HVA 346xp.

[stihlmadasever]

Stock 346xp flies on a 15".

As stubby says max 18" even on a ported saw

[htb]

Why spoil a good saw, unless its the only one you've got

[spudulike]

Stick a 13" on it and fill ya boots

[Pete Mctree]

I like my 18" , but then again I am allergic to bending over too far to cut little branches  

[Woodworks]

I had a 22" on mine for a bit. Clearly not ideal but it was the only saw I owned and had some big trees to deal with. It coped as long as the blade was sharp and you take your time. Keep the rackers long as it helps it to not take too big a bite. The saw is still going strong but now lives with a 15" which is spot on.

[Gerbutt]

5 minutes ago, Woodworks said:

I had a 22" on mine for a bit. Clearly not ideal but it was the only saw I owned and had some big trees to deal with. It coped as long as the blade was sharp and you take your time. Keep the rackers long as it helps it to not take too big a bite. The saw is still going strong but now lives with a 15" which is spot on.

Where did you get the 22" from?

 

Mines on an 18" at the moment and it screams, I'm sure it'd pull fine with a slightly bigger bar and a nice sharp chain. I've got bigger saws, just fancied trying a bit bigger on this one to see how it goes. 

[Joe Newton]

22" bar on a 50cc saw?

Just why?!

And calling it a blade will see you lynched in the street.