KWarb17
-
Posts
176 -
Joined
-
Last visited
Content Type
Profiles
Forums
Classifieds
Tip Site Directory
Blogs
Articles
News
Arborist Reviews
Arbtalk Knot Guide
Gallery
Store
Freelancers directory
Everything posted by KWarb17
-
Under the pump diaphragm. The side on the carb that has only 1 screw. Remove the end cover, the diaphragm and gasket carefully and you'll see the strainer👍
-
Go on then how much you get for it?😆
-
Sorry I meant...seems obvious if you put ash in a cupboard that it's not gonna be good 😆
-
Seems obvious enough?🤷♂️
-
Put one of these together back a few years ago...worked a treat until we got the skid👍
-
@Stihllymok
-
That's true😄 This was an absolute nightmare because the grain goes in all directions. Found that on a wide bar it would actually force the bar to bend down because the way the grain went! Ended up with a bow in the bar of about 20mm over a 60 or 70 inch bar. That was before I lost the teeth as well! Anyone else had this?
-
Totally feel your pain!! Had a short lump of yew that wasn't much more than 1.5m long. Had no less than 5 or 6 nails in it. We're talking large gauge nails! Lost 3 teeth and many hours of regrinding 😬🤨
-
You should see the new stone detectors 🤣👍
-
Honestly watched this so many times!! Loved every second 😅👍👍 Deffo keep them coming!!!
-
Agree, not had a lot to do with the 201 but the 261s and 500is seem sweet enough 😁
-
Ah but your talking husky ones😄
-
#captivesprocketnutsarethebest
-
Have you re set the M Tronic?
-
Very nice bit of timber there. How many hours of milling!?😁👌
-
How many times have you used/dealt with Forst?
-
Although at a guess Arbtalk is a very small percentage of their customer base👍😉
-
Thanks mate
-
Yes ok Have to file it down slightly to get it on and off??
-
Ok so having stripped down a 200t I've found a few problems. First that is a little concerning...a slight wear on the crankshaft meaning the worm gear won't come off because of this burr....any thoughts on the seriousness and whether new crank is need?🤨 Thinking it won't be good for the sprocket bearing??
-
Extremely good job👌 Could you dm a contact for repowder coating?
-
Sorry I was a bit half hearted🤦♂️ Nice looking 200 though...recent pictures?
-
I'll take a picture of mine when I'm back at the workshop...
-
Unscrew the orange lever on the side and prise it off the saw with a flat screwdriver...you can then unscrew the side cover and all the parts will stay complete inside Trust that makes sense👍
