Jump to content

Log in or register to remove this advert

milling pics and vids


burrell_
 Share

Recommended Posts

Cherry josh ?? Make sure you seal the ends if it is ... I was gutted when I looked through a stack I had milled and pegged up a few months back this week ,most of it was split! Didn't think that would happen as it had been on a pile for two years so if its green it will be far worse.

Link to comment
Share on other sites

Log in or register to remove this advert

  • 2 weeks later...
I installed a bench I made at the Village Hall today. see attached vid.

Made from Oak felled on a nearby estate, would have gone for firewood, I hope this is a better use! Cheers, Pup. :001_cool:

 

That is very clever, I like it a lot :thumbup1:

 

Do you have any side-on pictures from earlier in the construction which show how the back legs are done?

 

Alec

Link to comment
Share on other sites

some ash I done yesterday ps I did not cut the side someone else started the job and cut the sides as the only had a ms660 with a 36inch bar and had to cut the sides to mill

I have a bigger mill :thumbup1:

the heart wood was so nice I had to post pics

 

That's some really nice colour for ash. Doesn't seem to have lost much from the trimming up (and saved your chain a bit :001_smile:)

 

Alec

Link to comment
Share on other sites

That's some really nice colour for ash. Doesn't seem to have lost much from the trimming up (and saved your chain a bit :001_smile:)

 

Alec

Thank you Alec, you're comment is very kind. I'm going to try and post a side on picture, having a little trouble with the tech at the minute.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share


  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.