timberwolf feed roller probs

[Johny Walker]

iv had a similar problem. only mine was the infeed not reverse. a new latching relay sorted it for me.

 

the reverse works ,its the infeed thats stopped,

[Martin B Doyle]

sorry i miss read the post.

 

in that case its what happened to mind.

 

a friend gave me a new latching relay, plug in and off out to work again.

[Johny Walker]

sorry i miss read the post.

 

in that case its what happened to mind.

 

a friend gave me a new latching relay, plug in and off out to work again.

 

i swapped them around .still didnt run ,think its hodges paddle switch thats @ fault

[Shane]

Sounds like the switch, mine used to do it so I changed the switch and it was sound. No doubt someone will say its coz Timberwolfs are crap and you should of got a greenmech😛

 

 

Sent using Arbtalk Mobile App

 

Blimey.

[Ian C]

coz Timberwolfs are crap and you should of got a greenmech

[monkeybusiness]

Just check it isn't your belts slipping so the flywheel hasn't got enough revs to kick the stress control in. Or there is a problem with your throttle cable not giving the engine enough revs.

[treequip]

Sounds like an electrical problem the hydraulics for the feed rollers is controlled by electrically operated valves since it will go one way and not the other it's unlikely to be a flow or rpm problem.

 

Make sure three is a live to and from the switch (when operated). From memory that live then goes to a latching relay, find that and check it, the relay supply then goes to the solenoid valve, check the connections on that and if all that's ok check the coil pack

 

If you are still struggling I will be back Friday morning, you can bring it over.

[Timberwolf Official]

If you contact Timberwolf's technical support helpline with your machine model and serial number they will be happy to assist with your problem.

 

Timberwolf technical help can be reached on 01449 765820

[Mortimer Firewood]

Its what hodge said caused by water ingress just had mine done.

[Johny Walker]

Sounds like an electrical problem the hydraulics for the feed rollers is controlled by electrically operated valves since it will go one way and not the other it's unlikely to be a flow or rpm problem.

 

Make sure three is a live to and from the switch (when operated). From memory that live then goes to a latching relay, find that and check it, the relay supply then goes to the solenoid valve, check the connections on that and if all that's ok check the coil pack

 

If you are still struggling I will be back Friday morning, you can bring it over.

 

cheers andy infornative as always /,

 

ian, its not mine ,i couldnt lower my self to buy 1, not unless it was realy cheap