Jump to content

Log in or register to remove this advert

Chainsaw beginner - can't get Husq going after refuel


ATC1983
 Share

Recommended Posts

Right, spark plug out, choke in off position, on/switch in off position, turn saw upside down so spark plug hole is facing the floor and pull starter handle quite a few times to see if any fuel and or oil drains out, if so keep doing this until it there is no more fluid pouring out.

Clean and dry spark plug, warming the tip of the plug with a blow torch can help start a flooded engine.

 

Put the plug back in and start as from cold.

 

Good luck hope you get it running.

Link to comment
Share on other sites

Log in or register to remove this advert

  • Replies 86
  • Created
  • Last Reply

Top Posters In This Topic

I'm assuming this is the first time you have used a chainsaw and you haven't had any training.

 

I'd strongly advise you read the manual THOROUGHLY before using your new saw. Not only to ensure it is fuelled and maintained correctly but there are also important instructions for your own safety.

Link to comment
Share on other sites

I've taken the cs30, several months ago, but it was a 2 day course and have used the saw about 10 times since. I've just screwed up in refuelling, as use of a saw isn't a daily occurence for me.

 

is this a joke thread :laugh1:were you not shown this stuff wen doing cs30 :confused1:

 

:banghead::banghead:

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share


  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.