Snapping chains - how common?

[easy-lift guy]

Never had a chain break in 31 years. I have had them bent or the teeth damage by the sprocket. Have only ever bought new name brand chains.

My dealer made up about 10 for my Husky a few years back and still using and doing well.

easy-lift guy

[likeitorlumpit]

Never snapped

quite often just come off

[AA Teccie (Paul)]

All the more reason to ensure the chain catchers are in place and functional(this is one of the most common 'missing' chainsaw safety features we observe during the inspections)...just in case.

 

I agree that purchasing 'cheap' chains is probably a false economy and may carry increased risks.

 

Take care out there.

Paul

[daveindales]

I've also had dozens of chains snap over the years. Brashing gives them hell. But have never had a nasty incident. They certainly don't go flying too far off the bar. Probably due to chain catcher.

[Le Sanglier]

where to stihl and husqvarna get their chains? Do they buy them in? or manufacture themselves. Back to thread a few have snapped usually in the wood, no harm done.

[Rob D]

Don't think I've ever had a chain snap on me.... had a few come off the bar and caught on chain break, never with any injury.

 

If a chain breaks I'd say it's always down to a worn bar or worn sprocket and not the chain.

 

Not sure about the 'cheap chains' though as never tried any - but why you'd want them as a Stihl or Oregon chain lasts a good bit of time...

[hardtop110]

Any experience of Titan or Archer chains then?

[chilli]

I had always assumed that the recommendation given on training, to wear gloves, was to reduce injury from a flying snapped chain. But, the only time a chain has snapped on me, it just dribbled off the nose. I suppose it depends on where the 'snap' occurs as to whether the pull of the sprocket sends the remainder of the chain, still under tension, flying or not.

I only use Stihl chains & it was a well worn one on a 260 that broke.

[felixthelogchopper]

Any experience of Titan or Archer chains then?

 

I've used Archer chains before for cross-cutting and they seemed ok

[Jonesie]

where to stihl and husqvarna get their chains? Do they buy them in? or manufacture themselves. Back to thread a few have snapped usually in the wood, no harm done.

 

Stihl and Oregon manufacture themselves, Most if not all Stihl chain is made in Austria if I remember correct.

The only problems we have seen is if your making your own chains and the spinner is worn, it won't spread the rivet properly allowing the chain to much play at the link. This can cause chains to snap.