landforce chipper

[tree monkey]

my landforce chipper has stopped working

When you press the feed in button you have to keep it pressed in for anything to happen.

The feed out works when the in button is held in.if the stress control kicks in then it all stops ive tried most things anyone any ideas?

I think its the control box but not sure.

[Johny Walker]

buy a jensen or timberwolf:sneaky2:

[penfold]

buy a jensen or timberwolf:sneaky2:

 

thats what i've told him johnny,we know it makes sense:001_tt2:

[Ian C]

buy a jensen or Greenmech:sneaky2:

 

quite agree Jonny, ring hardmet Landforce 01386 834813, am sure they will help you out.

[Johny Walker]

quite agree Jonny, ring hardmet Landforce 01386 834813, am sure they will help you out.

 

your cruising my boy

[PeteB]

Sounds electrical to me, might be that the switch is not latching in the "On" position. Sell it and look at the "Quad Chip" I'm with it at Queensferry tomorrow.

[Mesterh]

Depending what the button does ie if it energizes a relay then it could be a dodgy relay.

[Nick B]

I had the same problem with my tw 125

It was a relay that needed cleaning up to get it going

I then replayced it with a new one

[skyhuck]

Get shut of the electrics and make it mechanical hydraulic controls only.

 

To comply with the stop button regs, simply put a sprung gate catch on the stop bar. So that when the bar is put in the stop position you have a hole the catch jumps into.

To get the rollers turning again you must pull the catch and move the bar.

 

Thats what I would do.

[Johny Walker]

Get shut of the electrics and make it mechanical hydraulic controls only.

 

To comply with the stop button regs, simply put a sprung gate catch on the stop bar. So that when the bar is put in the stop position you have a hole the catch jumps into.

To get the rollers turning again you must pull the catch and move the bar.

 

Thats what I would do.

 

bit like a jensen