Moody oregon chain

[TheHungrySquirrel]

Just made a trip to fr jones and bought a few goodies, picked up a spare bar and chain and after fitting notified the chain has two pairs of teeth on the same side like in the photo.

 

Anybody ever seen this? Only trouble is I have to wait for Monday to call them and sort it.

 

[Pete Mctree]

It is normal on some sizes of chain. Just the way the math works out

[Gray git]

Normal to find this sometimes as just depends on how many drive links in chain and where it was last cut and joined, won't make any difference to how it cuts or behaves, don't worry about it.

[TheHungrySquirrel]

I have never seen it and weird that it's in two places on the chain surely?

[Gnome]

As above this is normal, a good point to start sharpening your chain from as well

[Stubby]

Normal on an MS200t with 14" bar . Never noticed it on anything else . As said use it for start / finish point for sharpening .

[TheHungrySquirrel]

It's a 13" 56 dl chain. Just rummaged through 5 other chains I have and this is the only one.

[Johny Walker]

It's a 13" 56 dl chain. Just rummaged through 5 other chains I have and this is the only one.

 

are they all oregon chain , the oregon chain is a tad smaller than stihl chain,

[Stubby]

I would not worrie about it . It will cut just the same . It is normal on some chains . I have whole cutters missing when chain gets to the end of its life . Sharp as a razor but one or two cutters have knocked off . Still works fine . Sorta skip chain but not all the way round !

[Steve Bullman]

perfectly normal as already said