Jump to content

Log in or register to remove this advert

Stihl 024 bar movement


owain038
 Share

Recommended Posts

Log in or register to remove this advert

2 hours ago, EricBradley said:

A plate will do nothing to overcome the movement, the gap between the slot in the bar and the studs is so big I could drive a bus through without my glasses on.

Totally agree. Try taking the saw to a dealer and try a stihl bar on it.

Edited by outonalimb
spelling
Link to comment
Share on other sites

Bar number from 1st post shows as being the right one for a MS260 so assume the 024 is the same and therefore correct, def try the spacer
Indeed, ordered the bar and chain from a website (can't remember the name off my head) which required you to select your saw so it should definitely be correct. Have a inner plate ordered so hopefully that'll allow the cover to clamp down properly and hold the bar, will update when it arrives. Appreciate the help
Link to comment
Share on other sites

The studs are not supposed to be a real tight fit, you should lift the bar when tightening nuts and that clamps it tight to stop movement.

I notice the gauge is .050 whereas I think .063 would be normal, but that shouldn't be a problem. If you hadn't changed the studs I would say check the threads, I have seen damage that stops the nut going down before it gets properly tight against the cover. As you have changed the studs I would ask if they are definitely right and fitted correctly, and aren't stopping the cover closing

  • Like 1
Link to comment
Share on other sites



The studs are not supposed to be a real tight fit, you should lift the bar when tightening nuts and that clamps it tight to stop movement.

I notice the gauge is .050 whereas I think .063 would be normal, but that shouldn't be a problem. If you hadn't changed the studs I would say check the threads, I have seen damage that stops the nut going down before it gets properly tight against the cover. As you have changed the studs I would ask if they are definitely right and fitted correctly, and aren't stopping the cover closing


Cover does sit down perfectly flush around the edges with no gaps. Also have used 3 covers and two sets of studs so I think I can rule them two options out..
It's baffling me
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share


  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.