Jump to content

Log in or register to remove this advert

Drying Firewood when RHI payments stop.


arboriculturist
 Share

Recommended Posts

I would be getting specialist advice to be honest.

 

Power correction is quite easy option, you get a specialist in they measure the loads work out how big a capacitor bank is and you just do the math.

 

The fans though, that would be where i would be trying to get some saving. Talk to one of the big manufacturers they will know, someone like https://www.halifax-fan.co.uk/products/energy-efficient-industrial-fans

 

 

Link to comment
Share on other sites

Log in or register to remove this advert

22 hours ago, Woodwanter said:

No one can be sure. From what i have been advised, new set ups will be shut down, existing may be depending on what % of your total Tier 1 goes towards fuel drying

Quite, they have and can moved the goal posts. Any business plans for fuel drying need to stack up without the RHI in my opinion from now on.

 

would it be viable to use fossil fuels to take over instead?

Yes our business plan still stacks up without the RHI but the £400k I was sold as being “guarentee’ed” over the next 17 years would be more than annoying if they took it away. 

I havnt ever looked into the finer print of the terms and conditions of the RHI accreditation but if I was accredited under the information that the eligible heat was being used to dry fuel and they take that away from me before the 20 year subsidy ends (that they agreed the terms of the “contract” then I would be looking at the option of suing Ofgem for the £400k. 

  • Like 2
Link to comment
Share on other sites

You signed up in good faith but the powers that be know that they are 100% in the driving seat.

 

Any Barrister who agreed to consider legal action against a major league player will be looking for at least 5k deposited from your account into their's before they lift a finger, so that avenue will only ever lead you to a cliff edge.

 

It will be harsh on you if they are able to side-step what appeared to be signed and sealed.

 

In your position I would certainly be disecting those T&C's, just so you know exactly where you stand.

Edited by arboriculturist
Link to comment
Share on other sites

2 hours ago, ash_smith123 said:

Yes our business plan still stacks up without the RHI but the £400k I was sold as being “guarentee’ed” over the next 17 years would be more than annoying if they took it away. 

I havnt ever looked into the finer print of the terms and conditions of the RHI accreditation but if I was accredited under the information that the eligible heat was being used to dry fuel and they take that away from me before the 20 year subsidy ends (that they agreed the terms of the “contract” then I would be looking at the option of suing Ofgem for the £400k. 

I am sure plenty are in the same boat, it does seem bonkers that they are able to change the rules but I doubt they would be if they didn't have the legal ability to do so

Link to comment
Share on other sites

5 hours ago, HertsWood said:

Other ways to dry firewood without resorting to rhi route, which are still cost effective..

As RHI was only supposed to cover the difference in cost of a biomass boiler compared with a fossil fuelled onethere must be other ways:

 

1 second-hand wood fired boiler; they seem to go cheap enough I saw a 500kW  one that we installed 4 years before get knocked down for 10% of it's price

 

2 gas fired system to "polish" off the last few percent moisture content, on a large scale it can be had for under 3p/kWh and when you look at the O&M costs of a wood system the labour saving may be worth having

 

3 Make use of the downstream heat for heating a building.

 

incidentally I have a couple of bits of kit that didn't sell with my boiler, a 12kW fan coil unit and about 10m of Hep20 pipes for it and a circulating pump, could be ideal for a recirculating kiln.

 

Also a silo unloading auger and three phase motor with reduction gearbox, missing a drive chain, bearing and sprocket; As the boiler wouldn't burn fresh chip and needed it below 25%mc to burn at all cleanly I had intended this to use in a simple chip dryer by blowing heated air along it. In the past we had managed to dry fresh G30 chip down to 30% in less than 20 minutes with 90 degree air. With insulation and a little playing with angle of the auger I think one could dry 25kg of 50% green chip per hour with 12kW, down to 16.5kg of 25%mc chip

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share


  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.