Welshfred

Getting it bad in west wales now. Just back from a drive through llanwnen, llanllwni, brechfa, nantgaredig. Very bad, really horrible to see. In my woodland there seem only a few trees that are unaffected as yet. Does anyone have any info on how the larger branches break down? I plan to leave a lot standing for ecological value but have concerns about safety near tracks. Ash which died of other causes up to 10 years ago still have good standing inner crown structure but chalara seems to make the twiggy growth very brittle. How does this translate to larger branches im wondering? Any thoughts? Cheers...

I have 2 lovely benches at the kitchen table from very similar timber, legs cut from the same stock at full width. It really is beautiful timber, very hard though. Nice boards.

Actually, with a chainsaw mill... I use the ladder for every pass to avoid cumulative errors. The larch is very slow grown, planted in '56, any thoughts on whether that affects stability? Instinct says better stability...??? cheers

Good advice, thanks.

Yes, planning 25mm thickness. I like the idea of starting now in an ideal world but I have grant aided work to finish under contract which will keep me busy in the woods up to early winter 2018, then I can start on felling for building. First priorities will be roundwood framework and studwork, hopefully all from my own timber. Some long length 6x2 etc will have to be bought in in, then i'd hope to get on cutting cladding. Kilning? For exterior use? Other threads on here suggest using green or with minimal seasoning and relying on the fixings to studwork to hold the boards flat, full seasoning in situ from autumn onwards. Bearing in mind the op concerned through and though cut boards from centre of log so less prone to cupping. Given common tree sizes here these will likely be 6-10" wide ripped down to 8" max probably. I plan some experimental cutting this autumn though and could follw up with some experimental mounting. I have a shed to build too so good opportunities for practice. Cheers!

V Yes, if the timber is available, but most of what I have is too small for quarter sawing. What larger trees I have may need to be reserved for larger sawn sections or roundwood framing poles. Its all 50s planted Japanese larch, unthinned till the 90s so not many stems have reached good size. This thought had been niggling. Aiming to secure the boards at suitable intervals, prob 600mm would help keep them flat I hope, and not create gaps for wasps etc to enter the wall cavity. Concave could well be better structurally. I will look for some real world examples locally... Not cutting or building for a while yet (2019 probably) so hopefully plenty of time to work all this out. cheers!

Thanks both. Thats all good to know. I will have some larger timber but its prioritised for other elements of the structure so hope to get the large amount of cladding done out of my commonest tree size. I would imagine boards cut from a larger log, away from the core will run a higher risk of cupping due to the grain orientation - any thoughts on mounting these, convex vs concave to the outside? I reckon convex to reduce the risk of gaps opening between boards... cheers!

Hi, I'm hoping to mill cladding boards from larch but quite small diameter, 12inch dbh max. The boards will therefore contain heartwood, is this a problem? I've heard boxed heart can be an issue... Bit worried about warp across the board too (cupping?) or do you think this risk can be sorted with good drying and fixing? Have done a search, lots of good info but not quite what I need to know. Cheers!