TGB

Ah. And I thought it was my iPod Touch acting up. Doesn't always do it but have had an increasing problem with the app icon not responding. I've also found that sometimes while perusing a thread, (especially ones containing non YT vids) 'Arbralk' will shut-down back to the home screen.

I found that quite amusing... in a twisted way. There's many things that could be said of this pair but suffice to say, some people ought not be let loose in the world. And why the heck are they pleased about the job they've done? I really want to see the follow up vid, of them taking the tree over-hanging the pool.

Whether their targets work out on time, one can only hope. But they aim to get 35% of their elec. from renewable sources by 2020 and 100% by 2050. During the oil crisis of the '70s, Denmark which was heavily dependent on oil, was particularly hard hit. They decided then, that being dependent on other nations for the majority of their energy was a bad thing; and put their mind into doing something about it. They already have more trees planted for commercial use than existed in 1968. And are continually planting on a rotational basis.

£350 will get you a new stove but it will most likely eat fuel and be wholly ineffienct. This in turn will have you sweeping creosote deposits from flu twice a year instead of once. It's easy to say save & stretch the budget but maybe you can't do that in the shorterm. However, £480 and above will get you a cleaner buring stove, that in the long run should last you longer. Have a look through the classifieds and maybe you can grab a good stove, at a knockdown price. If the chimney has not been used in a while. Make sure it's still safe to use - no leaking fumes etc.

Heat pumps work best on SW -S facing walls, though can gather heat from other placements too. At their best, they can be a boon. At their worst, they can eat electricity. It is also important not to allow them to be obscured by overgrowth or allow things to be leaned against them. Vents must be kept clean and clear of dust, snow & wind blown debris for optimum efficiency. A British winter may cost you dearly. Damp air can accumulate water around the pump’s heat exchanger and this can freeze. This causes the heat pump to go into a defrost cycle, where the machine stops heating the house and uses electricity to defrost the exchanger. They can be noisy in use. Stated effectiveness and carbon savings quoted by companies, are usually based on mid terrace housing. Where there are only two exposed walls. Stats for detached housing are much harder to come by.

Does the bag hold water? What did the fish die from and is the fish edible?

One of the things you'll have to do before hiring a solicitor, is have a look through the fine print. Most motor insurance policies state that if a policy is canceled, the whole sum is payable immediately and in full. Since you have already paid in full, they may have a case in writing, that allows them to keep your money. I'm not saying it's fare, just that that may be the case. Insurance companies like banks, are a law unto themselves. If they can get away with it, (and keep your money as well) they will. And the law will back 'them' to the hilt. Insurance companies, like banks, aren't in their business to do you a favour. They're there to make profit for their shareholders and fat cat bosses. And if that means flogging you over a barrel, they'll happily do it and sleep soundly.

Yep. Last time I updated 1st Aid cert, tourniquet were touched on and above info given. Especially the 15min., release and retighten. If there's more than one person attending the casualty, assign one person to control of blood loss.

I also agree. I worked 13yrs. for a well known charity with large UK land holdings. It paid almost nothing, hardly a living wage for a frugal person. But I really liked both the job and being mainly outdoors. Ok so it had its downs but the ups more than made up for them. There's a great deal to say about enjoying what you do. You may not have a huge house house, you certainly have to think twice before buying something you want but may not really need. But how many people trudge through their working day, 50wks of the year, just so they can enjoy the other 2wks in the open air? Compare that to being able to enjoy, (all the time) what they aspire to, as they look at their screensaver of last year's holiday amongst the trees. If you have a reason to love your job and it may not be the money. Then enjoy it for what it is; for what it gives you that you'd not get elsewhere. If on the other hand, you dwell on the money others are making. I humbly suggest, you may be in the wrong job.

I don't see why not.

The sheep are realistic. Must take loads of time to mill fleece - from wooden to woollen.

Nice work. A good night's sleep is hard to beat and having a nice bed to slumber in, make even better. Sent by Arbtalk Mobile App

No comments on the garden furniture. However, if you come across canoeists, (and I don't mean kayakers) a favoured wood for thwarts, seats & wooden gunwales is ash. Its even grain and ability to slightly twist but spring back, is much sought after. A simply shaped & lightly sanded 80cm x 10cm x 2.5cm piece for a thwart, usually goes for £8 - £10 posted. If you bought on from a shop, it could cost up to £25. The paddler will then cut to final length, drill and treat before fitting. A 100cm x 12.5cm x 4cm for shaping into a carrying yoke, ranges from £15 for a planed blank, to between £20 and £70+ for shaped deep dish yoke. Gunwales run to £50+ for two times 4.8m x 2.5cm cm x 2cm planed. 5.2m in length would be a bit more. The paddler will then shape, drill, treat & cut to final length, as they fit to their particular canoe. Thwarts and yoke are normally posted but gunwales are normally collected. There's not that many people in GB doing wooden gunwales, so people are prepared to collect. Just one thing to remember. Paddlers will not buy or fit thwarts, yokes or gunwales that are twisted even slightly. It makes fitting a nightmare and leads to premature failure at points of contact. Sent by Arbtalk Mobile App

Very nice - and you say you're just starting. Good luck at the comp. Sent by Arbtalk Mobile App

I don't know how much of the total end-user cost are duties in Nordic countries. In GB, 78% of any gas or liquid fuel is duty. The nice people in government can then fiddle their accounts and claim for thing they don't own or need. If you want to enjoy life, work in the woods. If you want to enjoy the good life but be stuck in an office, work in government.

Agree brass would have looked better but with silver, you just need a light dusting now and then, with a periodic polish. With the brass, it would require more frequent polishing to prevent tarnishing. But it's still a thing of beauty. Sent by Arbtalk Mobile App

After checking local market - if you're going with 45gal. drums, one will give you an idea of quantity produced to amount of man-hours to produce. Sizeable but not too big holes in base or a number of slits cut with grinder should do. Open the top, also with grinder but don't remove top or rim. The top hole needs to be big enough to reach into, while still giving support for a cover, (a top-handled metal dustbin lid is good. Make the pieces approx. 12.5-20cm long and 50-75mm thick. Any bigger and you'll be getting some wood and some charcoal. Splitting the wood will give a great surface area to help remove all moisture. Place drum on three or four brick, on level area, allowing for even passage of air. Backfill earth around base of drum to maybe 15cm in height; allow around three points of initial air feed and close up to one small air inlet when kiln is going. If the area has been levelled out of a slope. Have the final air inlet on the downhill side, so if it rains and there water running down the slope, there won't be unduly moistened air entering the drum/kiln. Remember to seal top around cover with soil. You can compact this and as the soil dries, it will loosen, allowing passage for vapours. There's lots more to do but one of the main things after, (or maybe before) the burn starts, is making sure you have plenty of time to spare. In daylight, you prepare more wood for the next burn, read, etc. in bad light, it's down to singing songs,reciting poetry or listening to music and watching the wildlife. If you're using drums and are going to have a burn going in more than one at a time. Remember to give yourself working room between drum walls. So in one drum is finished before its neighbour, you're not burning your knuckle while emptying it. Get a comfy but weatherproof chair and or a tarp for shelter. If you've not got one already, get yourself a head torch. If you get cold, the drum/kiln walls are nice and hot but keeping your feet warm can be problematic. Be tidy, keep things in the same place and get yourself a large waterproof container for fire starting materials. Sent by Arbtalk Mobile App

I've had tennis elbow in both arms. Once at the same time. It flares now and then but at least I now what's going to happen next, so can deal with it promptly. After some rest and by that I mean not using that limb for heavy lifting, pushing and trying not to grip things tightly. You can aid both your immediate recovery and future flares, by shortening the problem forearm muscle. Now put that knife, needle & thread away. Instead but and arm strap from a sports shop. Something akin to http://www.amazon.co.uk/s/ref=nb_sb_noss/279-2668595-1834126?url=search-alias%3Dsports&field-keywords=Bracoo+adjustable+tennis+elbow+strap&rh=n%3A318949011%2Ck%3ABracoo+adjustable+tennis+elbow+strap Now there are more expensive ones and ones that shroud the entire elbow but all you really need, is something that clamps around the arm just below the elbow. This will in effect, shorten the working muscle and relieve the problem part of the muscle from undue strain. When you're well, just keep it in the 1st Aid kit for any future weakness in the same area. If you know what it is and catch it early, you can get it strapped and carry on your day. Just make sure the strap is adjustable, so you can wear it over or under different layers of clothing. Sent by Arbtalk Mobile App

As someone has already said, "Pay him and move on." Ok, so it might no be a pleasant experience dealing with him but don't stoop to his level. It's easy to make an enemy, harder to then get them off your back. Plus if you tell him where to go now; who knows what he might say down the line to potential customers of yours. You both move in the same circles, if not at the same grade. Keep quiet now and live with it. There are always going to be people in life, that are just grumpy as hell, to whom anything that makes them use connected brain cells, is beyond their reasoning. Sent by Arbtalk Mobile App

Where there's a way, there's a will. Don't fall in the fish pond. You could kill something or damage the pond. Don't run up and down the stairs. You'll wear the carpet out. He - She - They is/are a clown. Working together to fit new window casements. A friend of mine asked his father why he, (the father) had just partially crushed the son's hand and broken a finger with a lump hammer. And got the calm reply, "Why did you put you finger there." Sent by Arbtalk Mobile App

That vid never gets old, even if the tree did. Sent by Arbtalk Mobile App

You were evidently worried about the reading. I suggest that you ask your doc/nurse about the reading at the time. If next time it's low or high, you ought to know what that mean for you personally and being in the surgery, is an ideal place. Plus, if you ask right there and then, you don't need to wait for another appointment and can avoid any prolonged worrying. Sent by Arbtalk Mobile App

I humbly stand corrected. Thank you Woodkraut for your knowledge in this matter. Sent by Arbtalk Mobile App

Talking guarantee - Collect & Return is always handy. In the event of a breakdown, you just ring up the vendor, who arranges a pick up date by courier. Box up the hardware and then wait for the repaired/replaced hardware to arrive back at your door when all is done. Much easier than having to first find time to go to the PO and a great deal cheaper too. For small business needs, graphics and viewing photos can easily be handled with intergrated graphics as part of the CPU. The speed of loading photos/viewing 'YouTube' vids may be a little slower, (but not that much slower) as RAM used for graphics, will be shared with your main RAM. You'll only really need a graphics card with its own RAM, if you're playing games / editing video / viewing film in HD / regularly crunching big numbers.

Fair dos and thanks for the info. Sent by Arbtalk Mobile App