Breezeblock
-
Posts
2,312 -
Joined
-
Last visited
Content Type
Profiles
Forums
Classifieds
Tip Site Directory
Blogs
Articles
News
Arborist Reviews
Arbtalk Knot Guide
Gallery
Store
Freelancers directory
Everything posted by Breezeblock
-
no just an alternative to grinding carbide as it takes ages saturn do each tip for 5.50 + vat so they are relatively inexpensive hey it was just an out loud thought, could you post a pic of your tooth grinder set up as the one ive seen on youtube look like they take forever
-
has anybody thought about sharpening greenteeth with a plasma cutter just a thought as plasma will cut throughout anything that conducts electricity if you could rotate the cutters as you blow off the rounded off edge or even using arc air
-
got them on order it shows up how rough i am at operating stuff
-
the hurricane wont fit thru a 600mm wide gate the biggest issue we had today was keeping all the chip in are greenteeth quite bad for chip containment
-
sorted try it now
-
phone up the final drive centre no is 01473827145
-
heres a video of our new grinderfinally got it finished off i think its approx 3 months part time build cost less than £2000 [ame=http://www.youtube.com/watch?v=1N5TdVicmdw]YouTube[/ame]
-
£100 pm me
-
i would agree with that slew rings are a proper pain to do on a mini
-
turn the engine round about the opposite way and run a jack shaft with 2 sets of pulleys with your reduction on them and make your engine on a slide to use as a tensioner/clutch simples
-
get on with it you wont go rusty
-
possibly not as good as multi tip but saves changing the cutter wheel
-
change to greenteeth it saves removing the wheel and they use the same holes as the finger teeth
-
Where to find Norway Spruce for restoration project
Breezeblock replied to wildfisherman's topic in General chat
what about leylandii -
kohler is air cooled kubota is water cooled thats a major refit to put that in deutz power would be easier
-
ours from up above
-
pictures sounds like something not sitting in place
-
Uneven tyre wear on tunnisson chipper
Breezeblock replied to Grizzlybear's topic in Maintenance help
inflate them a bit harder or put a wider tyre on the rim go up maybe 10mm in width and try that -
i do ours piece of cake buy decent oil and filters
-
speak to eddy or david at jl steels they do decent stuff not the cheapest but deffo the best
-
we have one on our chipper seemingly bright orange isnt visible enough
-
and its only 600mm wide
-
28 hp deutz 1.5m wide sweep around about 350mm below and about 1100mm above and its on greenteeth on a lookalike greenwheel
-
standard double shield bearings i believe
-
been quiet at work for a couple of weeks now so been cracking on with the new grinder
