What's on your bench today?

[spudulike]

A better bet is to fill the bore with paper towel through the exhaust port, push the towl away through the plug hole and then tap with grease on the tap. Pull the towel out slowly, wind the piston up over the transfers and use an air line to blast the crap out of the exhaust port using the shape of the combustion chamber. done a few like it if I can but you have to be precise and have a knowledge of the ports.

[Darrin Turnbull]

In search of some parts for my 1985 Husqvarna 181 SE.

side plate , top cover and starter cover.

any help much appreciated 

 

[adw]

May have some bits, will have a look whats there.

[spudulike]

Been quiet after Christmas but think everyone is waking up now, One brush cutter, two long reach and around ten chainsaws came in last week! more booked to arrive next week!

[Darrin Turnbull]

Cleaning the side plate on the 150 , always quite messy .

Not the best design for shifting saw dust i think.
After

[spudulike]

Hope you cleaned under the inner cover as well!

[Darrin Turnbull]

thanks for letting me know. I'LL do that next time.

[spudulike]

Yes, the flat return springs break if crap builds up under the housing.

[Eddy_t]

Been a while since I've worked on anything, but had to replace my 560's exhaust gasket (again), a stihl ms260 that had a wrong carb diaphragm on it and a broken handle on an ms150t. I love the 150 but not working on the tiny little bugger!

[spudulike]

Be thankful it was only a handle - try working on the bottom end - miniscule little bits!