Today's milling

[trigger_andy]

22 minutes ago, AJStrees said:

What would you sell a slab of this oak for, 10’ long x 40-44” wide by 3’ thick, green.

£250?

[topchippyles]

20 minutes ago, trigger_andy said:

£250?

Muppet look at the quality very poor 

[Big Beech]

Last oak I had was 7ft x2” and 3.5 wide. Of similar quality…. I sold all but one slab x5 for £130 a piece.

yours is wider and thicker but I’d say 180 tops for an outside table.

[AJStrees]

Muppet look at the quality very poor 

I prefer The 250. Sounds much better

[trigger_andy]

Just now, AJStrees said:

I prefer The 250. Sounds much better

Les needs to stick to making Fence Posts. 

[AJStrees]

Last oak I had was 7ft x2” and 3.5 wide. Of similar quality…. I sold all but one slab x5 for £130 a piece.
yours is wider and thicker but I’d say 180 tops for an outside table.

Ok but the boards are quite a lot larger and in terms of quality, what are you referring to? I’m only asking, not challenging. [emoji106]

[AJStrees]

I prefer The 250. Sounds much better

Do tell Mr Les. Poor quality? [emoji106]

[Johnsond]

2 hours ago, topchippyles said:

Muppet look at the quality very poor 

Lot of Oak down your way Les, not so easy to find up in this neck of the woods bud. 
I was lucky and got hold of some decent enough stuff the other day. No problem shifting it at all up here Les if I wanted too. 

[Johnsond]

On 19/03/2022 at 18:24, bilke_user said:

Decent day for milling, apart from the strong wind blowing dust into the eyes

Larch cladding order halfway finished

That’s decent going for a  day, it’s always the same with the wind eh 🤷‍♂️. What do you use for the blade lube when doing Larch ??. 

[AJStrees]

11 minutes ago, Johnsond said:

Lot of Oak down your way Les, not so easy to find up in this neck of the woods bud. 
I was lucky and got hold of some decent enough stuff the other day. No problem shifting it at all up here Les if I wanted too. 

Very nice colouring on that.