Whats your multione loader doing today ?

[Stephen Blair]

21 hours ago, Dan Maynard said:

That's the best pyracantha picture I've ever seen.

Here’s my worst jaggy pic!  This was 1 of 4 growing up through a yew and into a Douglas fir.  2 days with a cherry picker, digger/ grab and flail!

  Ended up burning the debris as the flail just tickled it!

 

[doobin]

[AJStrees]

1 hour ago, doobin said:

Nice job are you putting in stainless steel rods to fix it?

[doobin]

13 hours ago, AJStrees said:

Nice job are you putting in stainless steel rods to fix it?

M16 studding resin fixed to the bottom, stuck the pillar back on and bricked up. Then drilled a 30mm hole at the back three courses up and poured in an SBR enriched slurry with flow additive. With agitation from some m6 studding that filled the whole thing three courses up. It was loose rubble fill so the original plan of resin both sides wasn't an option.

 

So next time it's hit it will break there!

Edited September 18, 2023 by doobin

[AJStrees]

26 minutes ago, doobin said:

M16 studding resin fixed to the bottom, stuck the pillar back on and bricked up. Then drilled a 30mm hole at the back three courses up and poured in an SBR enriched slurry with flow additive. With agitation from some m6 studding that filled the whole thing three courses up. It was loose rubble fill so the original plan of resin both sides wasn't an option.

 

So next time it's hit it will break there!

Nice! 

[Conor Wright]

Have this rather smart looking thing for a week long demo

Machine is a neomach nova x30.

26hp kubota,

1.1 ton lift

2.85mtr reach

3 sets of flow and return,

case drain and 2x12v connections.

on demo with a muratori flail and slanetrac fingerbar.

So far I'm reasonably impressed.

 

 

 

 

 

[doobin]

9 hours ago, Conor Wright said:

Have this rather smart looking thing for a week long demo

Machine is a neomach nova x30.

26hp kubota,

1.1 ton lift

2.85mtr reach

3 sets of flow and return,

case drain and 2x12v connections.

on demo with a muratori flail and slanetrac fingerbar.

So far I'm reasonably impressed.

 

 

 

 

 

Nice! Incredible that they will demo it with so many toys. What’s the price?

Edited October 12, 2023 by doobin

[Conor Wright]

12 hours ago, doobin said:

Nice! Incredible that they will demo it with so many toys. What’s the price?

Usually they wouldn't but I know them and they're keen to see what it can do, so I said give me the lot and I'll give honest feedback. It's a new venture for them too.

Machine is €35k with bucket and forks 

Flail and hedgecutter are 3.5 and 3 respectively 

[josharb87]

What’s the avant/multi one equivalent? 

[Conor Wright]

32 minutes ago, josharb87 said:

What’s the avant/multi one equivalent? 

Same as avant 630