Rate My Hinge.

[silky fox]

Looks tidy...Bore cut 😎

[Mark Bolam]

Slight flare at the butt there.

I would have straightened that up prior to felling.

[Steve Bullman]

Got a bad back Pete?

[18 stoner]

Cheers Paul. 😎

 

As for you other two critics, you are so predictable!🌳

 

All will be revealed tomorrow. Remember, sometimes "what the customer wants" and all that!

[Mark Bolam]

😂😂😂😂😂

[Caleb]

As much a question but why did you bore the hinge when you have as biger bar as that?

[18 stoner]

As much a question but why did you bore the hinge when you have as biger bar as that?

 

 

So it hinged easier😎

 

I think one of the lads took a vid of it going over, I'll see if I can get it off him. It's unlikely it would of fallen on its own if the hinge was full width. Hope that explains. 👍

[Caleb]

Ok cool, I understand!

[Joe Newton]

As much a question but why did you bore the hinge when you have as biger bar as that?

 

 

He didn't mean to. He was clearly using a smaller bar for the face cut, and over cut the centre of the hinge with the nose.

 

Bloody poor work IMO.

[Pete Mctree]

Bit of a mismatch on the bore cut height, but tidy Pete.

A couple of 12ft chunks I had to pull with the loader - just shy of 3ft diameter, so the groundies heard my full range of vocab as I hauled the 660 up there !