Cleaning chipper blades

[karl]

Just a question.....does anyone use a ultrasonic cleaner for blades ...saving scraping and wire brushing them 

Cheers

[PeteB]

Scrape and wipe on both mating faces. If the bolts are in a recess, clean that out too. Ditto washers.

[karl]

Already doing that pete.....as usual I'm looking for an easy option that can be done whilst I have a coffee ?

[gdh]

I just use a flap disc on a cordless grinder which is pretty quick.

[PeteB]

3 hours ago, karl said:

Already doing that pete.....as usual I'm looking for an easy option that can be done whilst I have a coffee ?

Give it to the apprentice then!

[gdh]

5 hours ago, Scottish Cleaning Service said:

Not heard a flap disc before?

One of these. https://www.screwfix.com/p/erbauer-zirconium-flap-disc-115mm-40-grit/4300G?tc=HA8&ds_kid=92700055262507123&ds_rl=1244066&gclid=CjwKCAiAtK79BRAIEiwA4OskBhr1k9gO60b-ciVWdoWZZ2MFs5wwy7on2YtWWaTrKr1L8vKP7bM2lxoCrqgQAvD_BwE&gclsrc=aw.ds

[aspenarb]

A few forks full of sweepings fired through gets most of it off.

 

[Mick Dempsey]

39 minutes ago, aspenarb said:

A few forks full of sweepings fired through gets most of it off.

 

Is there a chipper that has suffered more than your TWs?

[maybelateron]

2 hours ago, aspenarb said:

A few forks full of sweepings fired through gets most of it off.

Sweepings off a welders workshop??

[monkeybusiness]

3 hours ago, Scottish Cleaning Service said:

Visited my local sawmill to buy some timber and I had a look at their nearly new TW428. They said it cost nearly £40k and uses hammers to break down the wood into chips. I can't see it on the TW site so I guess its discontinued. If anyone can tell me how it works then I would be much appreciated.

I think it uses hammers to break down the wood into chips... 

You mean a 426 - I think they are still available. 
https://www.benburgess.co.uk/shop/timberwolf-tw-s426tdhb-diesel-hydraulic-shredder/