Question

[aspenarb]

I have got to remove this lump, its over thirty feet in circumference and I would like to take a slice off the diameter about 3" thick to build the mother of all garden tables. Whats out there that could cut this accurately ? Dont say a topper or a silky saw:)

 

Edited November 5, 2014 by aspenarb

[wisewood]

What's the diameter?

I've cross cut big logs with an Alaskan but I'm guessing it may be too large for one. You may just have to cut it freehand.

Where are you? I'm after a nice big gnarly lump.

 

Sent from my Nexus 7 using Arbtalk mobile app

[se7enthdevil]

What's the diameter?

I've cross cut big logs with an Alaskan but I'm guessing it may be too large for one. You may just have to cut it freehand.

Where are you? I'm after a nice big gnarly lump.

 

Sent from my Nexus 7 using Arbtalk mobile app

 

divide by PI buddy... one over 30' in circumference will be 9-10' diameter so i think you may have to do that free hand.

[wisewood]

divide by PI buddy... one over 30' in circumference will be 9-10' diameter so i think you may have to do that free hand.

 

Ah! Nice one, that's handy to know :-)

 

Sent from my Nexus 7 using Arbtalk mobile app

[Copford sawmill sussex]

Shame your not near us we can mill 2m wide accurately with our new milk

[bobh]

Shame your not near us we can mill 2m wide accurately with our new milk

 

That must be some cow 😁😁

[Copford sawmill sussex]

Ha ha oops

[aspenarb]

A smaller version of the one below would do, if I could only find someone with a bar about 15` long. We have pulled quite a few humungous sticks back into the woods over the years and had to leave them where they are , its just too much grief and a logistical nightmare to do anything else with them there is a really nice lump of oak around 12foot in diameter which we had to roll back into the woods , the only way to it is a cross a playing field that cant be mashed up with big trucks etc so it would have to dealt with where it is.

 

Bob

 

http://arbtalk.co.uk/forum/attachment.php?attachmentid=168606&stc=1&d=1415310957

[se7enthdevil]

Shame your not near us we can mill 2m wide accurately with our new milk

 

wont be big enough for that sucker then, 10' is 3m...

[Big Beech]

What happens to the 2 1\2 times guide bar rule? Surely a GB 64" bar would do the job with bit of buttressing?

Edited November 7, 2014 by Big Beech