Chainsaw lanyard

[silky fox]

Strop to the left hand side here too.....Twas a Game changer.

[Mark Bolam]

Did you lads flap around like a college boy a bit at first?

I'd had my strop on the right for years, and it was built into my muscle memory.

It wasn't till I started high-clipping my saw a few years back that I had to change.

Much better in every way.

[billpierce]

why is it better on left when high clipping then? i've just got used to having my strop in left to avoid the saw on right!

[silky fox]

It was a flash in the pan moment for me Bolam....i quickly swapped sides while nobody was looking and..... "Eureka!" 😆

[Rich Rule]

I clip onto the treemotion attachment point. That is in the middle. I usually short clip it on the right hand side.

[Mark Bolam]

why is it better on left when high clipping then? i've just got used to having my strop in left to avoid the saw on right!

 

 

I high clip my saw on the right, so swapped my lanyard to the left to avoid tangles.

[Gerbutt]

The lanyard goes in front of you and not behind?

[Mark Bolam]

Saw lanyard clipped to rear centre, high-clipped to caritool on rhs.

My positioning lanyard is now clipped on my lhs D.

[Gerbutt]

Ahhhhh I see, that makes more sense, I thought it was just the chainsaw one you were talking about!

[justo7]

I was taught by a lefty so I followed his set up. Chainsaw strop attached at back centre of harness, high clipped on left side on carrytool. Work positioning attached on right side. Also silky or left just in front and lower than carrytool. Don't have any problems. Tried switching but it's like learning to brush my teeth with my opposite hand