Larger disc chippers

[Steve Bullman]

but can you supply full support and back up parts ed? thats whats important

[Mr Ed]

but can you supply full support and back up parts ed? thats whats important

 

Yup. Beaver Plant now provide full UK backup.

[Marc]

Just out of curiosity, as i know nothing about such things but why do you want a large pto chipper? Why not a large chipper with its own engine is it a cost thing?

[arc]

Yup. Beaver Plant now provide full UK backup.

 

Now that is handy,

[Stephen Blair]

marc the tractor set up is good for the 4x4 around sites. if i could i would of put the chipper on the trailer sideways for site work, then i could put it on the tractors linkage for tighter jobs.

[Marc]

marc the tractor set up is good for the 4x4 around sites. if i could i would of put the chipper on the trailer sideways for site work, then i could put it on the tractors linkage for tighter jobs.

 

See i live and work in the urban sprawl that is the south, i forget there is such thijngs as open spaces, The most of road i go is backing it into someones garden.

 

I liked this Bandito chipper you could get it onto most sites, hydraulic top feed roller and handy winch. Not good for biomass as its spits kindling more than chip. Reasonably priced second hand from what i know, and parts should be easy to come by, looked well built to boot.

 

I know nothing though and should keep out of such topics.

[Dean Lofthouse]

I bet it fills the cab of that fastrack quick

[Stephen Blair]

thats the fella marc, i noticed the chip was splintery, the winch is great but i havent had it on a job yet to give it a run

[Marc]

I bet it fills the cab of that fastrack quick

 

It'll fill a 7.5t truck in under 15 minutes when presented with a steady stream of material.

[Dean Lofthouse]

thats the fella marc, i noticed the chip was splintery, the winch is great but i havent had it on a job yet to give it a run

 

Check the anvils, make sure the edge is sharp and square and the gap is right and check the metal of the opening isn't worn at the end of the anvil where it sits