Husqvarna grease gun.

[Stubby]

Stopped greasing nose sprockets . Now they don't fail . I think the grease attracts grit and dirt increasing he risk of failure so don't bother any more . Seems to be working fine for the last 5 years or so .......

[fergusonforestry]

we had about five of these lying round 'not working' one day I decide to take a look every single one was down to no being bled or no used right best one was the one that had two of the cap bits inside one on top of grease and the other under it no wonder it didn't work

[Chris Sheppard]

As above - I don't tend to bother greasing nose sprockets and on the whole the bar's worn before the sprocket goes.

 

But, for greasign the clutch drum bearing, the only grease gun that I've found to work consistently are these ones Grease Gun - New Saw Chains It says single use on the ad but have refilled mine no prob.

 

I had one of the metal oregon ones too and it was cack - used to leak everywhere and hardly ever worked.

[peatff]

Stopped greasing nose sprockets . Now they don't fail . I think the grease attracts grit and dirt increasing he risk of failure so don't bother any more . Seems to be working fine for the last 5 years or so .......

 

Where does the dirt get in, through the grease hole ? If there's a grease point on anything I grease it.

[SawTroll]

why does the husky bar need greasing when the stihl ones don't?

 

They don't, unless you started doing it - then you have to follow up.

 

What needs to be greased now and then (but not weekly as the manual says) is the clutch bearing - and that is really easy on the Husky saws, with the grease gun, and the hole in the end of the crankshaft.

I never had an issue with the stock ones, except that it took some time to figure out how to refill them....

[ThrustSSC]

The REALLY good one to have is the AmPro one, but they're really, really hard to find... Looks like I'll be picking one up in the USA next time I'm over there.

[Hodge]

Never had a problem with my grease guns???

 

 

Sent from my iPhone using Arbtalk

[Brushcutter]

 

I had one of the metal oregon ones too and it was cack - used to leak everywhere and hardly ever worked.

 

Mine does that too. Wasn't happy red grease all over the inside of the tool box. Waste of a tenner really.

[Valtra1982]

You need to find an old style metal one with the chain/plunger inside. The plastic guns are hopeless.

[carlos]

Timberjak Chainsaw Bar Tip Grease Gun Kit for Dolmar Echo Oregon Bars | eBay

 

 

how about these ones?? looks good.