Spuds Porting and Tuning Thread

[spudulike]

Wow, that meteor is huge. I'm gonna go clean up that cylinder now, I reckon.

 

It gives a lot more potential but would make sure you ask your supplier about it before going mad - you can use the link for guidance!

[div_h]

You done much porting work lately

[spudulike]

You done much porting work lately

 

Done yours for starters and got a 357XP to do:thumbup:

[div_h]

Done yours for starters and got a 357XP to do:thumbup:

 

Nice 1 what did you set the rpm too? I'm happy with that saw, got it it for £211 of ebay

[treewizard]

Ported my 038:thumbup1:

[spudulike]

Nice 1 what did you set the rpm too? I'm happy with that saw, got it it for £211 of ebay

 

It has a limited coil but you can feather it up to 13,900 and it juuussssttttt goes loopy at the very end so low 14000 - it may take more but like to build in a little safety! Check the plug colour after a good bash with it - coffee colour is good!

 

Lucky I found the leaking seal - would have been toast very shortly!

[spudulike]

Ported my 038:thumbup1:

 

Any pictures of the internal ports and transfers?

[wyk]

I hope you didn't grind out the tonsil if it had one on the intake side? That's to keep the ring in check.

[spudulike]

I hope you didn't grind out the tonsil if it had one on the intake side? That's to keep the ring in check.

 

[Tom D]

i have 2 saws to send to you, could you send your address again please. Thanks.