MS200T not oiling

[Stubby]

sorry stubby....but I did'nt tell him to buy a husky!

 

Jesting with you Matty ...just jesting !

[spudulike]

Take the oil pump out and give it right old clean out...

 

Squirting WD40 in there will hopefully clean and blast any crud out. Had it with a problem on one of my saws and it sorted it a treat.

 

Yes Rich.....you did didn't you - think I will run a phone service help line as well!

 

The worm drives rarely wear and the pickup pipe filter or plugged pump are the usual suspects:thumbup:

 

If these parts are fine then the pumps do wear to the point they stop working:thumbdown:

[H-A]

http://www.declicmotoculture.com/fs/Root/6xp56-MS200T_MS200.pdf

 

Page 4 shows the pump bits, so you know what you are looking for.

 

H-A

[spudulike]

Take the clutch off - spin it clockwise to do this, remove the clutch drum and bearing, three screws and remove the dual side cover, remove the worm drive, remove the two retaining bolts on the pump and pull it off the oil channel connector block and remove the pipe.

 

Make sure the same oil pump retaining screws are used to fit the pump back on as if you use longer ones, you will punch a hole in to the inner crank case:thumbdown:

[Mark Bolam]

Thank you very much, it really is appreciated.

[Rich Rule]

Yes Rich.....you did didn't you - think I will run a phone service help line as well!

 

The worm drives rarely wear and the pickup pipe filter or plugged pump are the usual suspects:thumbup:

 

If these parts are fine then the pumps do wear to the point they stop working:thumbdown:

 

forgot to mention, I was only the hands operating under the telephonic instruction of a god like being.

 

:blushing:

Edited November 27, 2013 by Rich Rule

[spudulike]

forgot to mention, I was nearly the hands operating under the telephonic instruction of a god like being.

 

:blushing:

 

always a pleasure:001_rolleyes:

[Stubby]

always a pleasure:001_rolleyes:

 

:lol::lol::lol::lol::lol::lol:

[2stroke-ady]

9 times out of 10 its a clogged pump inlet, much easier to fix it with a T540 though!!

[Mark Bolam]

I now have the most lubricated bar in town.

Blockage in the pipe. Worm drive still in good nick.

 

Thanks again for the help fellas, and God bless Arbtalk!