Jump to content

Log in or register to remove this advert

The dreaded Carpel Tunnel Syndrome / white finger


Bowlander
 Share

Recommended Posts

Hi, i am fortunate not to be dependent on a chainsaw to make my living at the moment. However, i do have my basic CS30 & 31 and i was looking at a career change.

 

In September 2011 i worked in scotland for a couple of weeks with a husky saw, clearing Rhododendron. I wore gloves, the saw didnt have heated handles but it wasnt cold. I had pins and needles in my hands for two weeks after that trip. It wasnt painful, just strange. In june this year i did only a couple of hours chainsawing and had the mild pins and needles again in the afternoon. I have seen my GP who reckons that it could be carpel tunnel :confused1:

 

I have taken to wearing wrist braces at night and doing some exercises. Its not painful and i hope that it clears completely.

 

So should i sell the chainsaw and give up the dream? I really dont want to go down the route of needing an operation. I would appreaciate advice from folk who've had experience of this. Thanks very much.

Link to comment
Share on other sites

Log in or register to remove this advert

Maybe ask your GP to refer you to a specialist - there's probably a fix available if you speak to the right person, which might not be a generalist doctor. Alternatively look for a good sports massage/therapy person.

 

Whereabouts in Bowland are you? I used to live just outside Chipping.

Link to comment
Share on other sites

I have the same but mine is really painful at night, had injection in both my wrist of steroids to try and stop the swelling of the nerve, but have only taken the edge off, only two options left, give up the saw work or have the op, looks like I'll give the op a try, seems quite quick, takes about 15min under a nerve block in your arm. Good luck,

Link to comment
Share on other sites

Not sure you would get carpel tunnel in such a short frame time unless you increased a problem that was already there. Are you in IT?

It is not white finger that takes a long time to develop 10 years +. Its either your hands are not used to the vibration of the saw or you have slight carpal tunnel already.

I had carpel tunnel through saws and the pc and I went private and had steroid injections, one on each wrist. That was about 10 years ago and i not had any problems since so its not the end of the world. Failing that a operation which takes 40 mins to an hour and can be done under GA will totally resolve CTS.

Copper bracers help alot if your in pain now.

Keeping your saw sharp is a must too :) Hope this helps :)

Link to comment
Share on other sites

Hi, i am fortunate not to be dependent on a chainsaw to make my living at the moment. However, i do have my basic CS30 & 31 and i was looking at a career change.

 

In September 2011 i worked in scotland for a couple of weeks with a husky saw, clearing Rhododendron. I wore gloves, the saw didnt have heated handles but it wasnt cold. I had pins and needles in my hands for two weeks after that trip. It wasnt painful, just strange. In june this year i did only a couple of hours chainsawing and had the mild pins and needles again in the afternoon. I have seen my GP who reckons that it could be carpel tunnel :confused1:

 

I have taken to wearing wrist braces at night and doing some exercises. Its not painful and i hope that it clears completely.

 

So should i sell the chainsaw and give up the dream? I really dont want to go down the route of needing an operation. I would appreaciate advice from folk who've had experience of this. Thanks very much.

 

Have the opp , it a doddle . Its day surgery in and out . A few stitches in your hand . I had it done and never looked back . Mine was caused/manifested itself buy motor bike track days . .

Link to comment
Share on other sites

Hi thanks to Proclimber et al for all your comments. I think i will see a private physio for a confirmation of diagnosis. GP's can be a bit hit n miss. I got the intense pins n needles after probably 3 full days / week chainsaw use over two weeks. It could have been brought on by the fact that i went from an occasional saw user to a full time one too quickly!

 

I do use computers a lot for work but i thought i had good posture. I think i've been overdoing it on the typing though, doing long hours. Its a combination of things.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.