The clip-n-trim....

[Ian Flatters]

whilst scowering the interweb i found this Granberg International a chainsaw mod that makes it a kind of hedge cutter.

[Matt Butler]

don't think that i'd like to use that, looks a bit dangerous

[skyhuck]

I think that looks quite a good idea!!!!!!!!

[Stephen Blair]

yikes 19 dollars, must be very well built lol, does the chain stay on the saw?

[Johny Walker]

does if u keep over tight !

[skyhuck]

yikes 19 dollars, must be very well built lol, does the chain stay on the saw?

 

Yeah, the chain still does the cutting, the prongs will just hold it still while its cut, instead of all the thin bits being pulled towards the saw body.

[tree_beard]

looks like a reasonable idea...

 

only for electric saws tho... would eventually kill a proper saw, saw carbs are not jetted to be run like a hedgetrimmer... revving away without a load on em

[skyhuck]

looks like a reasonable idea...

 

only for electric saws tho... would eventually kill a proper saw, saw carbs are not jetted to be run like a hedgetrimmer... revving away without a load on em

 

I would only use it on very woody hedges, Laurel, Hawthorn and the like, so there would be a load.

[tree_beard]

unless you were constantly blipping the throttle it still wouldnt be the best idea for the saw... bit like limbing a felled pine by holding the throttle wide open and walking down the trunk... saws is saws, hedge trimmers is hedge trimmers:001_smile:

[Johny Walker]

just need some 1, to try it dave !,