Bandmill rollers - where to buy?

[trigger_andy]

Logosol Mills use the same Rollers, so if youre ever needing to change them out (not just the bearings) then drop them a bell, prompt delivery as well 

[Dan Maynard]

Well, I pressed out the bearings this morning - so simple, just use an appropriate size socket and hold the roller on the jaws of an open vice so there is a void for the bearing to go into; and whack the socket with a hammer.  Can't believe I didn't try this years ago.  Have ordered replacement bearings online at a cost of £4 each and it takes two per roller.  Pressing them in will be a sinch so happy days and thank you for the helpful suggestions. 
 
Arbtalk comes up trumps again.

Good job.

[Squaredy]

4 hours ago, trigger_andy said:

Logosol Mills use the same Rollers, so if youre ever needing to change them out (not just the bearings) then drop them a bell, prompt delivery as well 

Ah thanks Andy.  It turns out the Woodmizer ones were too small internal diameter, but for a while now I will be fine once I put the new bearings in.

[Wonky]

Done Like most bearings I have to change. Ie the stihl strimmer head. And I just brought the correct bearings from a bearing supplier. At a 1/4 of the price of stihl

 

i'm pleased it worked out for you 😉

[Forest2Furniture]

I've just had a price from logosol for two guide rollers, £54 each plus VAT & delivery total cost £141.54.