Echo 2511 repair

[wicklamulla]

 Hi,    I damaged the fuel filler 'neck'  (where the filler cap screws into) and it now has a hairline crack which allows fuel to escape.  Is there any sealer or glue i can use to seal it up?  @spudulike

[peatff]

JB Weld is fuel resistant if you can get it into the crack. 

[Will Heal]

I’ve mended fuel tanks with araldite before

[openspaceman]

10 hours ago, Will Heal said:

I’ve mended fuel tanks with araldite before

Yes but try and use the original rather than the rapid version. Mix the components very well and warm it with a hair dryer as this makes it set stronger and quicker. It also makes it far more runny

[woodwizzard]

https://www.ebay.co.uk/itm/5-Second-Fix-Liquid-Plastic-Welding-Kit-Fix-Repair-and-Seal-Anything-UK-FAST/253129883875?epid=1356491477&hash=item3aefb780e3:g:XO0AAOSwFHNazMvA

 

https://www.ebay.co.uk/itm/5-Second-Fix-Liquid-Plastic-Welding-Kit-Fix-Repair-and-Seal-Anything-UK-FAST/253129883875?epid=1356491477&hash=item3aefb780e3:g:XO0AAOSwFHNazMvA

[wicklamulla]

thanks folks.

[Martin Tree Care]

Will any of the above work on my cs2511? 

Similar problem mine wont hold fuel or oil !!!!!?

[carlos]

ouch!!! 

send it to spud

[Martin Tree Care]

Will do, sure he would like a challenge!!!

Nearly new when it was digested by a big bad timberwolf.

Crank, piston, flywheel all in 20mm bits!! Easy fix?

[peatff]

9 hours ago, Martin Tree Care said:

Will do, sure he would like a challenge!!!

Nearly new when it was digested by a big bad timberwolf.

Crank, piston, flywheel all in 20mm bits!! Easy fix?

Lucky it didn't do more damage  Karabiner looks like it will go again.

Edited August 29, 2018 by peatff