550xp wont start

[htb]

Where did you get saw from, banchory or huntly?

[spudulike]

10 hours ago, Peasgood said:

My mate had his remapped.

Well I guess your mate knows the Husqvarna Software development engineers then as there is no way to "Remap" the autotune as some seem to think there is.

[Stubby]

3 minutes ago, spudulike said:

Well I guess your mate knows the Husqvarna Software development engineers then as there is no way to "Remap" the autotune as some seem to think there is.

See that's were you are wrong Steve . You can put on contour lines , hills ,valleys , roads , foot paths , bridal-ways etc etc ?

[spudulike]

Like sticking an OS map on the top of the saw? Does it make it go faster?

[Stubby]

2 minutes ago, spudulike said:

Like sticking an OS map on the top of the saw? Does it make it go faster?

Of course ! ?

[elfie]

5 hours ago, htb said:

Where did you get saw from, banchory or huntly?

Bought it online as I bought it without the bar.  

[htb]

So bob wont want to touch it then

[Sveriges]

Yes unfortunately all a load of rubbish what the dealer has told you. Firmware does alter the saw in how it runs and performs to some extent. There are often updates for various reasons and if the dealer has there end up to date you will get the updates when your saw is next plugged in. 

 

As said tho it doesn’t need the latest firmware to run. It needs firmware but it wouldn’t of ran on the production line if it didn’t have any. As said above they are  still a chainsaw and nothing has changed in how you go about repairing them. When I  work on one which has either seized or is running bad  I can  tell whats caused it without even needing to plug it in. The auto tune is actually very very reliable despite what people may think. 

Edited June 14, 2018 by Sveriges

[Peasgood]

3 hours ago, spudulike said:

Like sticking an OS map on the top of the saw? Does it make it go faster?

He put go faster stripes on it as well. Goes like a rocket!

[elfie]

Received the saw back last Wednesday and used it for a job on Saturday and the same problem occurred after a period of time..... it is going back to online shop again.  I have request either money back or a new saw as I cant operate with intermittent equipment with less than 10 hrs on it.

 

They say they have to inspect before they can make a decision.