560XP 20" bar

[AllyH]

Finally got myself a 560XP and I'm needing a 20" bar and chain to remove some large stumps. A mate gave me an Oregon bar (number 208PXBK095) but not sure if it'll be suitable. Any ideas what's the best, and will the 560XP handle a 20" ok? Cheers

 

 

Sent from my iPhone using Arbtalk

[Woodworks]

Just got myself a 560 with Oregon Pro-AM 20" bar. The saw runs it lovely like a hot knife through butter. Pity is had the nose bearing seize twice already. Been told to take it back and change but not a good start for the bar.

[TheHungrySquirrel]

That bar with the 095 mount sounds right just need to check wether it's 050 or 058

 

Run a 24 on mine occasionally and it pulls it ok but it's only a 60cc saw

[AllyH]

Yea it's a .058. Aye a think the biggest I'd go would be 20 but like I say it's only to cut some stumps level. I usually run it with the 15 on it

 

 

Sent from my iPhone using Arbtalk

[MattyF]

Turn up the oil pump to the max.

[stihlmadasever]

Can you get a sugihara bar for it perhaps

[Stubby]

Are you running the original .325 or have you converted to 3/8ths ?

[AllyH]

Are you running the original .325 or have you converted to 3/8ths ?

 

 

Yea still running the 325

 

 

Sent from my iPhone using Arbtalk

[Stubby]

Yea still running the 325

 

 

Sent from my iPhone using Arbtalk

 

Ok . What ever you are running I would recommend the Sugihara Light weight pro bars . All my saw now have them . I have tried all sorts over the years .

[NFG]

Hi

 

I dont have a 560 but can recommend Sugihara bars, see Robs site at

 

Chainsawbars selector for chainsaw guide bars, chains and sprockets

 

Check your gauge as SH do a .50 narrow kerf as well as a .58 for the 560

 

 

N