Dolmar

[Ian Leach]

Would you want a 3/8 carving bar and chain

 

Or a 1/4 sprocket and 1/4 bar and chain

 

And size 10" bar or 12" bar :thumbup:

 

Thanks

 

Erm new to carving with a proper carving bar so don't know 12" 3/8 I guess saves me changing sprocket when I used the other bar.

[wisewood]

Erm new to carving with a proper carving bar so don't know 12" 3/8 I guess saves me changing sprocket when I used the other bar.

 

Ian, if you're going down the 3/8 lopro route you are limited to a quarter tip bar. If you want a finer tip for detail you'd be better off with a dime tip bar but yes you would need to run 1/4 carving chain and would have to change sprockets.

[Ian Leach]

Cheers for the advice.

[shavey]

Ian, if you're going down the 3/8 lopro route you are limited to a quarter tip bar. If you want a finer tip for detail you'd be better off with a dime tip bar but yes you would need to run 1/4 carving chain and would have to change sprockets.

 

Thanks for posting that wise wood i didn't have a clue about this fact with the different tips :thumbup:

Cheers

[wisewood]

No problem Andrew, out of interest are the sprockets over or under the clutch on these saws? If over then not too much faffing to swap between 3/8 and 1/4 bars/chain.

[shavey]

No problem Andrew, out of interest are the sprockets over or under the clutch on these saws? If over then not too much faffing to swap between 3/8 and 1/4 bars/chain.

 

The sprockets are over the clutch drum one circlip and washer and your done very quick :thumbup:

[wisewood]

The sprockets are over the clutch drum one circlip and washer and your done very quick :thumbup:

 

Does that include the 3410?

Hope so, nice and easy 😁

[shavey]

Does that include the 3410?

Hope so, nice and easy 😁

 

 

Yes exactly the same :thumbup:

[wisewood]

Yes exactly the same :thumbup:

 

Great 👍

[arbormonkey]

Any news on the release date for the new top handle