New double ended chainsaw bars from GB

[shavey]

Bummer but respect your decision.

 

hello mate try Forstbedarf & Jagdshop - Produkte für Wald und Natur bei Grube - Grube KG they got alot on there site :thumbup:

[bolthole]

Hi Rob,

 

I've recently bought a 'job lot' of nearly new Makita DCS 510s. I'd love to start milling - do you think two of these on a 50" bar would be a viable setup?

 

The manual says their maximum power is 3.3hp. Either a .325 or 3/8 pitch, but I'm not at home to check...

 

What do you think?

[Rob D]

Hi Rob,

 

I've recently bought a 'job lot' of nearly new Makita DCS 510s. I'd love to start milling - do you think two of these on a 50" bar would be a viable setup?

 

The manual says their maximum power is 3.3hp. Either a .325 or 3/8 pitch, but I'm not at home to check...

 

What do you think?

 

 

 

I reckon these may have the K095 mount or similar in which case they won't work - but if the slot for the bars is 9mm then possibly but I think they may be too small for the large mounts on these bars even with spacers.

[bolthole]

I reckon these may have the K095 mount or similar in which case they won't work - but if the slot for the bars is 9mm then possibly but I think they may be too small for the large mounts on these bars even with spacers.

 

Thanks Rob. I'll check it out when I get home (end of the month) and PM you.

[Rob D]

Ok no worrys

[Big Beech]

That's got me thinking rob.

090 & 070 combo. Ideal!!!

[agg221]

That's got me thinking rob.

090 & 070 combo. Ideal!!!

 

Nope.

 

One day, when I get round to it I will fit an 090 each end of the Stihl mill. That will be quite fast I suspect

 

Alec

[burrell_]

:-) Alec u need to find a new big job and this will happen :-)

[tommy d]

Hi would this system work with an 036 and 441 so it would and what would else would I need to buy to get started. Sorry to bother ye but I am a complete novice where chainsaw milling is concerned.

[Rob D]

Hi would this system work with an 036 and 441 so it would and what would else would I need to buy to get started. Sorry to bother ye but I am a complete novice where chainsaw milling is concerned.

 

 

It would.... but a double ended set up is not for novice milling - too big a jump.

 

 

 

I would cut your teeth on a single mill to start with.

 

 

Rob