Chip box airflow.

[carlos]

Because it's too long!

 

 

Sent from my iPhone using Arbtalk

 

ours is exactly the same , it does block on wet stuff ocasionally , is that the reason for shortening them??

[treequip]

out of intrest why are you guys suggesting shortening the greenmech chute?

 

See post 1:laugh1:

[Kenty]

You could always increase the distance between the truck & chipper therefore decreasing the amount of chip that blows out.

[carlos]

just looked at the photos of the back of the mog and id say the doors at the back are way to low, on the one at work the are about 3/4 high and we can fill to the brim, that said greenmech raised the height of the chipper chute at the turntable by about ten inch. i have seen other mogs with a notch cut out of the doors i would say that is the best solution.

carl

[openspaceman]

Definitely.

 

The spout in the box is causing your problems

 

Speak withGM they will calculate the minimum length of spout to stay in compliance with the CE standard it was built to

[Stephen Blair]

You could always increase the distance between the truck & chipper therefore decreasing the amount of chip that blows out.

 

 

Much much simpler

 

 

Sent from my iPhone using Arbtalk

[carlos]

Much much simpler

 

 

Sent from my iPhone using Arbtalk

 

how would you do that??

[treequip]

You could always increase the distance between the truck & chipper therefore decreasing the amount of chip that blows out.

 

How would you do that.?

[Stephen Blair]

how would you do that??

 

 

I was being ironic

On phone so no wee roll eye faces.

Tbh the way your chute angle is from the chipper isn't helping, this is going to create a splatter pattern of chip, a nice swan neck is what your after

 

 

Sent from my iPhone using Arbtalk

[treequip]

Speak withGM they will calculate the minimum length of spout to stay in compliance with the CE standard it was built to

 

It's not mine and it wasn't built to a CE standard, they don't produce standards for chippers or anything else.

 

The length of the discharge won't be an issue for CE marking but the height would be, you can get the height you need without all that length.