Spuds Porting and Tuning Thread

[spudulike]

I hope matty is reading this and shipping a delicatessen your way then! He hasn't sent the short block?

 

I now have the block, handle and an array of parts that may...or may not make a saw - thats life with Matty:sneaky2: It is OK, he is a decent guy and I am only taking the piss.....a little.

 

I will be interested to see if the saw does what it should once done:thumbup:

[woodwizzard]

Have you ported any 550xps' and will the auto tune adjust enough for it? What sort of money are we talking if so

[spudulike]

Have you ported any 550xps' and will the auto tune adjust enough for it? What sort of money are we talking if so

 

I haven't personally done a 550 to date, this 560 I have done has had a life and the top end was hanging on a wire until I worked a little magic. It has had A LOT done to it and if the auto tune handles it then I think others will follow suite.

 

The machining gets done at the weekend and the rebuild a week later - just too busy to get it done earlier.

 

Cost - PM me for a few costs if you are interested.

[woodwizzard]

Will see what the outcome of the 560 is and go from there:thumbup1: A ported and tuned 560, that will be a total nutter

[Eddy_t]

Will see what the outcome of the 560 is and go from there:thumbup1: A ported and tuned 560, that will be a total nutter

 

 

They are! Mine out cuts anything I've ran against it!

[MattyF]

Gets some vids up eddy!

[woodwizzard]

+1 on the vid please.

[Eddy_t]

+1 on the vid please.

 

 

Would if I could, anyone know how to upload a video?

[spudulike]

Need a comparison using the same bar, standard machine if possible!

 

Forgot to tell you Matty - your piston ring and circlips arrived for the attention of Miss Fxxxxx

 

I know you wear your hair long but is there something you are not telling me......did that Monty Python Lumberjack song have a lasting effect:001_tt2:

 

Just kidding:lol:

[Eddy_t]

Need a comparison using the same bar, standard machine if possible!

 

 

 

Forgot to tell you Matty - your piston ring and circlips arrived for the attention of Miss Fxxxxx

 

 

 

I know you wear your hair long but is there something you are not telling me......did that Monty Python Lumberjack song have a lasting effect:001_tt2:

 

 

 

Just kidding:lol:

 

 

Unfortunately I can't compare the same set-up as stock, as I run 9t on 18", whereas the work's saws are 7t 15". Although I'm confident that even with the bigger bar, it'll piss all over them!