Show us your Arb Diggers please.

[jonnygurkha]

I’m being dense but I can find any tap or handle

[Conor Wright]

2 minutes ago, jonnygurkha said:

Check where the offset ram goes in under the cab, should be a bolt head/lever sitting there looking out at you! 

[LGP Eddie]

TB016 are a bit of an oddball in this respect.

 

Most think they’re one way piped because they can’t find the taps, but the answer was under their foot all along.

 

You’re just the other way around going from two way to single.

 

Simply adjust the foot pedal stops to suit.

 

Eddie.

 

 

[Matthew Storrs]

16 minutes ago, LGP Eddie said:

TB016 are a bit of an oddball in this respect.

 

Most think they’re one way piped because they can’t find the taps, but the answer was under their foot all along.

 

You’re just the other way around going from two way to single.

 

Simply adjust the foot pedal stops to suit.

 

Eddie.

 

 

Might be ok for some attachments. But for example when I’m using a post knocker it needs to be in proper single acting mode so that when I press side B of the pedal it dumps the fluid back to the tank  as the hammer falls. My old TB016 and subsequent 216 had a lever next to the offset ram to easily change between the two…

[LGP Eddie]

46 minutes ago, Matthew Storrs said:

Might be ok for some attachments. But for example when I’m using a post knocker it needs to be in proper single acting mode so that when I press side B of the pedal it dumps the fluid back to the tank  as the hammer falls. My old TB016 and subsequent 216 had a lever next to the offset ram to easily change between the two…

They simply weren’t piped up like that as many Minis were simply single acting at the time and unusual to be two way facility.

 

Not a huge job to put a tap in and back to tank on the return if required.

 

 

Eddie.

[jonnygurkha]

They simply weren’t piped up like that as many Minis were simply single acting at the time and unusual to be two way facility.
 
Not a huge job to put a tap in and back to tank on the return if required.
 
 
Eddie.

Eddie, would your arrangement of simply adjusting the foot pedal work with this or does it need a tap putting in do you reckon?

[LGP Eddie]

Anything with a motor will generally benefit from least back pressure possible and certainly generate a lot less heat than back through the block.

 

 

Eddie.

[doobin]

Have you bought the flail yet?

[jonnygurkha]

Have you bought the flail yet?

No, not yet. I’m not 100% convinced about it.

[doobin]

1 hour ago, jonnygurkha said:

No, not yet. I’m not 100% convinced about it.

Good, cause it’ll be useless on such a small machine. They’re not much use on a 2.7t, never mind a 1.5