todays little project

[burrell_]

took this ash down 2 weeks ago the customer wanted me to carve a lump out the trunk to make a seat so i said i will have a go never done any carving work before

now the idea was to carve it out with the 441 and do the finishing of with the 200 but as never of them wanted to run i done it with the 660 and a 30inch bar j

[spudulike]

Nice one Martin

[WeeDee]

Neat work, but will it roll forward and crush the sitter (Indiana Jones style)?

[burrell_]

cheers spud

i but the alasken mill across the both but didnt get a pic of the

just found the pic of the tree the whole befor and after

[Rob D]

Nice looks like you did a good job getting all the cuts to meet up

[Glen Poole]

I like that, very nice & neat work

[James Cantle]

nice seat. all that potential firewood! haha good job

[timtree81]

waste of fire wood ,looks good tho

[burrell_]

after buying new bigger rails form ROB D and some other bits

i ended up mill this bit of elm

wanted to use the 076 on it but i felt with a 48inch bar it would be a bit big so decided to do it with the 660

[spudulike]

Martin - I have a problem with this, here I am plastering over artex in my kitchen, covered in crap and you are out there having fun with your hareem of chainsaws. it just isn't on:001_rolleyes:

 

Nice job, good grain and think you are right about the rock hard wood I was describing to you - it is elm, same grain and colour!

 

Nice new toy - I have a new bit of kit on order - something to play with on the next "Boys day out":thumbup: