Holder A60 Engine rebuild

[Dolittle]

Hi,

Im trying to get an A60 engine back together, but Im struggling to find any workshop manual/ information relating to torque settings and tappit adjustment etc...

 

Can anyone here help please.....

 

(otherwise I may end up with a number of very expensive  novelty paperweights to put on ebay)!

[PeteB]

Sometimes, bolt torque and tappet settings can be common to other similar engines etc, try some lateral thinking and find the bolt sizes then look at other engines etc? Good luck with the hunt for the correct settings  though!

[MrNick]

Holdertractors.com/sales-service/spare-parts/spare-parts-lists-older-models/

Don't know if what you want is in there ! I'm sure Lamberhurst Engineering had some association with holder, try them.

[Dolittle]

Thanks, I have tried Lamberhurst, they have offered little help apart from emptying my pockets

I'm waiting to hear back from Holder... 

Fingers crossed! 

[tcfengineering]

When I had my A55 engine in bits, I couldnt find any torque settings, so I just used the same settings as a fordson Dexta thinking it was a similar engine. I put it all back together a couple of years ago and it has been totally fine since. They are very robust engines and I think they will be quite forgiving.

[Dolittle]

OK, will try that if nothing else comes to light

Thankyou 

 

 

[renewablejohn]

PM me your email address and I will send you my C500 manual files. Its basically the same tractor but reverse drive.

[njtimber]

On 07/03/2021 at 17:16, Dolittle said:

Hi,

Im trying to get an A60 engine back together, but Im struggling to find any workshop manual/ information relating to torque settings and tappit adjustment etc...

 

Can anyone here help please.....

 

(otherwise I may end up with a number of very expensive  novelty paperweights to put on ebay)!

Hello , I have some information regarding your engine 

[njtimber]

5 minutes ago, njtimber said:

Hello , I have some information regarding your engine 

 

[njtimber]

1 minute ago, njtimber said:

 

Hope this helps .

Thanks Nick.