1990 Husqvarna 240r handlebar clamp

[openspaceman]

I got the brushcutter off my garage ceiling to give it a service ready for next season and for some inexplicable reason the 4 bolt hole clamp that secures the handle bar has split. It's part number 502 11 37-02 and not generally available. Before I attempt to fabricate a new one I'm after suggestion who may still have some new old stock?

 

Perhaps @adw?

[htb]

Husqvarna 240r Strimma Spares Or Repairs.

WWW.EBAY.CO.UK

---

<p>Husqvarna 240r Strimma Spares Or Repairs. Have had it going but was I pig to start and once going it kept cutting out...

Any use?

[openspaceman]

2 minutes ago, htb said:

Husqvarna 240r Strimma Spares Or Repairs.

WWW.EBAY.CO.UK

---

<p>Husqvarna 240r Strimma Spares Or Repairs. Have had it going but was I pig to start and once going it kept cutting out...

Any use?

Thanks but no, that is the post 1991 model with the quick release three bolt clamp. Mind for 15 quid if I lived near Newton Abbot I'd have a punt.

[htb]

Vintage stuff then.

[openspaceman]

2 minutes ago, htb said:

Vintage stuff then.

It's one of my newer bits of kit, in fact I only have a younger 262xp. The 084, FS360, 254, 2*262 etc are all 1980s plus an older Husky 2100, the hedgcutters are younger. The tractors are older than many posters here. I was mostly machine driving after 1997 and became employed in 2009.

[adw]

I will check it out in the morning, they were available in Jonsered and Partner different colours,however the later support post and clamps would fit.

[gand]

I'll have a look at work in the morning, sure I stripped one of them down. It's surprising how many old stock parts there seem to be in boxes