Ported MS200t running 1/4 bar and chain.

[Gerbutt]

Did this for a laugh really but it’s actually really good!

 

[Stubby]

There is a squad of the top handle police on here . They will be sending you to prison ! ?

Edited September 24, 2019 by Stubby

[Gerbutt]

It was filmed in another dimension where up is down and down is up, right is left and left is right, right is wrong and wrong is right [emoji3]

[billpierce]

Is that running the rotatech chain? Looks reasonably rapid

[Gerbutt]

Is that running the rotatech chain? Looks reasonably rapid

No it’s on the stihl chain in this vid, I’d previously used it for a reduction and it leaves a better finish on the cuts.

[billpierce]

No it’s on the stihl chain in this vid, I’d previously used it for a reduction and it leaves a better finish on the cuts.

Sweet. Let me know how the bar and chain hold up with a 200 powering them

[Mick Dempsey]

Tbh,  I don’t find it very impressive, poplar, soft as you like.

 

Not really all that.

[Gerbutt]

It’s great on a large beech reduction, neat and good fun. I do know what you mean though, the chain does struggle.

[Mick Dempsey]

Different strokes and all that.

 

It feels like pulling a breeze block around when I drag the 201 around these days.

All about the echo 2511 for me these days.

[john p]

Different strokes and all that.
 
It feels like pulling a breeze block around when I drag the 201 around these days.
All about the echo 2511 for me these days.

I bought an 8” bar for mine, that an a drilled exhaust makes it absolutely fantastic! 201 never comes out of the truck these days...