562 sprocket choice??

[TheHungrySquirrel]

Anybody have an idea on what's available to fit the new 562xp??

 

If I'm right it's a small spline 19mm 3/8 7t as stock???

 

I'm trying to figure if I could get a 404 sprocket on it which would let me run semi chisel full skip

 

 

[Sveriges]

Standard it should be a large spline. 560XP is on the smaller spline. You could get an 8tooth sprocket which will just fit without adding a link to the chain and with enough adjustment left on the side cover. 

 

Can’t really help with your 404 idea, sounds plausible though if you can get a bar to suit which I’m sure there will be. 

[Khriss]

What is it yr actually cutting ? That tends to dictate wt yr choice of bar length n sprocket size is , K

[TheHungrySquirrel]

What is it yr actually cutting ? That tends to dictate wt yr choice of bar length n sprocket size is , K

Will be for up the tree and ringing up on the floor when I don't want to use the 3120

Ideally want a 28" on other with the skip to reduce cutters in the wood.

[Khriss]

Hardwood or softwood ? An full bar length or limbing ? K

 

[Khriss]

( You dont ask much )

[TheHungrySquirrel]

( You dont ask much [emoji6] )

I know [emoji12] probably a mix of full length for clogging down and occasional use in the woods for limbs.

Also used for ringing up stuff in the yard.

[shavey]

You will find your best option would be a 24” - 28” D009 mount  3/8 050 or 058 full house full skip ,  404 063 will be a hard slog 

but if you want a 404 set up just get a sugihara 3/8 063 bar and change the tip too 404 

[Steve Bullman]

wouldnt even consider running 404 on a saw that size.  Can I ask why you are considering that an option?  I assume you buy it on the reel?

[TheHungrySquirrel]

wouldnt even consider running 404 on a saw that size.  Can I ask why you are considering that an option?  I assume you buy it on the reel?

I'd like to run full skip semi chisel chain but I do t think it exists in 3/8?

But it does exist in 404