Ms150 tc muffler mod

[Pbtaylor2014]

Hi guys thinking of modeing my ms150 its about 3 weeks old so should i wait or do it and what's the best way thanks

[spudulike]

There was a thread about this subject not so long ago, should tell you all you need to know.

[Pbtaylor2014]

Thanks spud

[Richard Thompson]

I've put a couple of louvres in my ms150 exhaust, I used a dremel cut off wheel and screw driver/flat pliers to open up the vents

 

Edited June 17, 2016 by Richard Thompson

[Pbtaylor2014]

I've put a couple of louvres in my ms150 exhaust, I used a dremel cut off wheel and screw driver/flat pliers to open up the vents

 

 

 

Did you have to adjust the carb it's 3 weeks old so do you recommend now or wait for the warranty to run out thanks

[geoff]

If it's done a couple of hours work it would be a good time to do it, you may have to richen up on the H screw 1/8 to 1/4 turn, (anti clockwise).

[Richard Thompson]

I did as Geoff said just richen the carb a little, and just do the mod now as long as you look after the saw yow should be ok rather than waiting for a year for the warranty to run out

[Pbtaylor2014]

[ame]https://vimeo.com/171219135[/ame]

Hi giys don the mod how does it sound haven't touched the carb settings yet seems to cut good trying to upload but Taptalk says the video is to big only a 1 minutes long please advise welcome as don't want to damage piston ect it's only a 3 weeks old [emoji4]

It seems ther is a stop on the h screw as can turn clock wise but not anti clockwise so i can go no furthe than it could before?

Sent from my D5803 using Tapatalk

Edited June 18, 2016 by Pbtaylor2014

[Rich Rule]

Pull the plug out after a running the saw for a few cuts in the log. Have a look at the colour. Do the same again and check the colour and adjust accordingly.

 

Just don't pull the cap too hard as I pulled mine off!

[Stubby]

Do a plug chop . Load the saw in the cut , flat out , then hit the kill switch and check the colour .