show us your chip trucks

[Theocus]

I think nay as i made that one, but styling if it was like it!!

[Mozza]

I think nay as i made that one, but styling if it was like it!!

 

You made that Iveco???

[Lightmart]

I have only just read this thread.

 

The truck belonging to Tommer looks cool....I wish I had one like that:thumbup1:.

 

Lightmart

[Mozza]

was working with mick the otherday and we spotted this little beauty, american truck, looked well cool ( sorry for poor pic, we wer at the lights and it was well sunny )

 

Is that the same one thats in the classifieds for sale??

 

Cant be too many about

[burrell_]

Theocus is that a new vermeer BC160XL i can see on ur rear end

[Theocus]

Yes it was, we had it on demo for the day as looking to change my chipper. um er its a nice colour for sure!!!!!! Wont be buying one though. We did try the Bc200, thats a good chipper though.

[timtree81]

I think nay as i made that one, but styling if it was like it!!

 

sorry my mistake ,my iveco reg was x913 ekk ,its was idedical to your one

[Dave C]

 

This is my Transit Tipper with county 4x4 mod. It's a bit old but I love it:thumbup1:

[ACUF]

I just purchased a Valby / Farmi Ch150 gravity feed chipper to run off the rear linkage on the Cabrio U900, as it has the bed extensions for large duties, not pictured. It does just fine at a low engine RPM on the 540 setting.

 

This is the first time I have used a Unimog to chip and I'm quite impressed. I cant wait to use the white CH140HF (hydraulic feed), but am waiting on a redesign of the high flow system, to switch between the aerial lift and the chipper, on the Case U900. The last image is when I went and picked the chipper up after it was delivered.

 

ACUF

Edited October 3, 2010 by ACUF

[jpbeaver]

my toyota dyna, just had the new back put on.