More 200t problems

[Tom@JPU]

I replaced the block and piston on my 200 and thought I had fixed it, yet I still had problems with the running of it after carb fiddling. Slapped a new carb on it and still refuses to run any suggestions?

 

Sent from my HTC One using Arbtalk mobile app

[Stubby]

I replaced the block and piston on my 200 and thought I had fixed it, yet I still had problems with the running of it after carb fiddling. Slapped a new carb on it and still refuses to run any suggestions?

 

Sent from my HTC One using Arbtalk mobile app

 

Send it to spud and/or get a T540 ......

[Tom@JPU]

I would get a 540 but I can't part with that sort of money at the moment. I'll have to contact spud I think

 

Sent from my HTC One using Arbtalk mobile app

[Stubby]

I would get a 540 but I can't part with that sort of money at the moment. I'll have to contact spud I think

 

Sent from my HTC One using Arbtalk mobile app

 

He your man !

[Rich2484]

Depends on what the running issue is. The crank seals may be shot. This means it starts to run lean. The same is also with the carb boot.

[spudulike]

I have been contacted:lol: Probably a carb issue but like to start from a solid base so will check the saw out for leaks before doing any other work......there can't be too much wrong with it .......can there:confused1:

[GardenKit]

....there can't be too much wrong with it .......can there:confused1:

 

Of course not:biggrin:, its only a little saw. Simples:

[spudulike]

Of course not:biggrin:, its only a little saw. Simples:

 

Yeah, little saws have less to go wrong:blushing:

 

Just evacuated the garage - MS880 just fired up that the guy said wouldn't start - think the crankcase is full of fuel:001_rolleyes:

 

It's a pea souper:lol:

[peatff]

 

Left over oil burning off ? I had that with my Dynamac it sounded like a crosser till it cleared it's throat