Quadchip no stress not working

[maxi]

Has anyone had any experience of the no stress device on a quadchip not working ?

[Shane]

I had a brief problem when the flywheel sensor worked loose -

the revs were showing as all over the place. The infeed stopped because the perceived revs were too low.

 

I just tightened up the sensor (next to the 'star wheel' on the engine side of the flywheel)

 

If the engine revs show the correct value (about 2,400 IIRC) best contact greenmech

[Gray git]

Check your belt tension and clean the censor as crud can build up on the face of it.

[maxi]

Cheers , went to check the belt tensioner earlier the tensioner has snapped

 

,

[Gray git]

That will be your culprit then! Has it been greased regularly? Not the easiest to get in to but needs doing.

[maxi]

Yeah it's been greased regular got to swing the tanks out , hopefully get a part tomorrow

[Tom D]

I saw you today in juniper green…

 

unfortunately greenmech are no longer sending out parts, you have to get them from hendersons, so be prepared to wait!

[maxi]

Damn , could do without that , spoke to Alistair from greenmech earlier so hopefully he can speed it up a bit ,

[PeteB]

I saw you today in juniper green…

 

unfortunately greenmech are no longer sending out parts, you have to get them from hendersons, so be prepared to wait!

 

Not true Tom, we do send out parts, and we can send them direct to you. But, the bill will come from the local GreenMech dealer. We set up a Nationwide dealer network for Sales of new machines and part of that organic growth is for the dealer to do service work and spare parts. In doing that, owners not only have the comfort zone of being able to talk to someone at GreenMech, but, also a local supplier!

 

Parts can be sent to a dealer, or direct to you, even dispatched on a friday for a Saturday delivery if it is desperate and the cost bearable.

 

Furthermore, the GreenMech website shows the phone numbers of Alastair, me, Julian and Martin, the Sales Director so we are all contactable and not hidden away from sight!

Edited December 17, 2013 by PeteB

[Ian C]

Sounds good on paper pete but it aint in practice as you know!

 

Why go through a dealer when they have no parts and no parts prices and know very little about the machines.