makita DCS9010 seems a cheap deal

[Big J]

Thanks for the number for the spares Tom. I put my order in for a DCS9010, so looking forward to getting the 'battleship' out on a few jobs. It will be nice not to have to keep switching between the 18" and 28" bars for the DCS7901 at the yard.

 

Jonathan

[WoodED]

changed the studs on mine so I can use standard husqvarna guide bars... works great

 

 

Where did u get these mounts buddy?

 

 

Sent using Arbtalk Mobile App

[shavey]

Where did u get these mounts buddy?

 

 

Sent using Arbtalk Mobile App

 

hello ed i got a set off ebay and they where £3 free p+p here is the ebay number 3508 0046 9076

 

cheers :thumbup:

[Stihl dealer in Scotland]

Oiler is around £20.00. You have been had mate :-(

[Ghilley]

Iv got two dcs 9000,s and a 9010 the ignition has just gone bad on the 1994 9000 after a hard life but iv just got a new flywheel and ignition module from the states for less than £100 . these saws rock they are built like tanks iv cut thousands of tones of timber with them

I run a 42 inch bar on the newer 9000 it pulls like a train the 9010 revs faster I run a 22 inch on her for felling I also own a ms 660 but just seem to use the dolmar/ makita saws always a talking point as there the wrong shade of blue for most folks liking LOL I remember having a dolmar 166 years back they are built along the same lines but that 166 was the most powerful saw iv ever used and iv used them all

[TimberCutterDartmoor]

Iv got two dcs 9000,s and a 9010 the ignition has just gone bad on the 1994 9000 after a hard life but iv just got a new flywheel and ignition module from the states for less than £100 . these saws rock they are built like tanks iv cut thousands of tones of timber with them

I run a 42 inch bar on the newer 9000 it pulls like a train the 9010 revs faster I run a 22 inch on her for felling I also own a ms 660 but just seem to use the dolmar/ makita saws always a talking point as there the wrong shade of blue for most folks liking LOL I remember having a dolmar 166 years back they are built along the same lines but that 166 was the most powerful saw iv ever used and iv used them all

 

Oh the 166! Should never EVER have sold mine!!! What a saw!

 

Parting with the 133 was a dumbass thing to do too.

Edited May 7, 2014 by TimberCutterDartmoor

[Ghilley]

Sorry to high jack the tread but What a tool 166 . iv just had a dig about and iv found a brand new 42 inch wide mount bar together with new recoil starter and side cover ,fuel tank with manual oiler and AVM'S rear handle with dead mans trigger , front handle ,felling spikes and jungle mufler all brand new old stock for the king of saws 166 They must be worth a bob or two

[flatyre]

Hey folks there is a Makita 9010 on the local gumtree, looks pretty fresh with a 3ft bar, if its a torque monster as described earlier would it make a good milling saw for small to mid sized timber?

[woodwizzard]

I mill with a 7900, so the 9010 should breeze it. I'm deffo a makita convert and just picked up an ea5000 to go with the 7900.