Jump to content

Log in or register to remove this advert

What's on your bench today?


spudulike

Recommended Posts

Log in or register to remove this advert

our Mountfield 725m is well over 10years old , only ever had to replace the cutter cable as is had been routed next to the exhaust, went to drive it outta the shed and it was making a loud clicking noise from the axle... stripped it down and the gears are all worn, went to local agent and they wanted £220 for a new axle even though its only the 4 gears I need. Any ideas on fixing the axle without spending so much moolah.

Cheers Gav

Link to comment
Share on other sites

our Mountfield 725m is well over 10years old , only ever had to replace the cutter cable as is had been routed next to the exhaust, went to drive it outta the shed and it was making a loud clicking noise from the axle... stripped it down and the gears are all worn, went to local agent and they wanted £220 for a new axle even though its only the 4 gears I need. Any ideas on fixing the axle without spending so much moolah.

Cheers Gav

Sorry Gav, your dealer is correct. The gearbox is only sold as a complete unit. No internal spares are available The current RRP is £243 plus vat

Link to comment
Share on other sites

A busy couple of days. A partner strimmer needing new fuel lines.

 

A mcullock hedge cutter needing repair to handle. And four mower blades to balance and sharpen.

 

Also got the ms250 in, tested and used, punched well above its weight cutting and was fine. Not rally sure what to do about it. Will get some timber and get the customer to use it in front of me. Only thing I can think of doing.

 

Also fitted a fog lamp kit to a hilux.

Link to comment
Share on other sites

Do you mean the gear head?

 

If so remove the plates strip the gears out and clean, any degreaser works ok. The refill with the correct grease.

 

And when the gearbox is apart and clean check all gears and shafts for wear.

 

Obviously strip it down in a manner that means it easy to remember how it goes back in again.

Edited by Rich2484
Link to comment
Share on other sites

Fill it with gunk degreaser from the hole where you put in the grease and replace the plug then give it a shake about and turn the spindle by hand for while and tip the resulting mess out of the hole. Repeat a few times and that should be job done. Best off if you can fill it up and leave it overnight to break the grease down.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.