Custom Tarps/sheets

[Billy]

I rmember seeing a few chipboxes with custom made (or at leas they appeared to be) tarps and sheet for the roof of the chip box, i've searched around on ebay for these and can't seem to find any so if any of you withthem are reading this i'd like to know where to get one.

[Kiwi climber]

seam seal, near Thame/Ayelsbury...

[Paul Antrobus]

Stuart canvas products, Warrington, just ordered my new one off them.

[Treegeek]

Where are you there's a company called dobie wyatt near marlborough wiltshire

[eggsarascal]

There's a company just outside Sudbury Suffolk that do them. Could find out the name if it's any good to you.

[Chris Gagen]

Tarpaulin,Trailer cover,Made to measure tarpaulin, PolyTarp,Canvas,Boat cover

 

had baz brackenbury make a couple of spec sheets for me, a roll-over cover for a farm trailer and a tarpaulin for a conventional baler. brilliant guys there and open to a deal with firewood involved...

[Billy]

I'm In Kent, thanks for all the replies. i'm not 100% decide donthsis tyle yet, what do you guys think are the benefits over a flat roof? I just realised without a flat roof section i'm not going to have anywhere to put my ladder which could be abit annoying...

[White Noise]

Billy just make sure you got some kind of vent system as our tarp covered chip box doesnt half blow dust back in your face . We tend to have the chipper a few feet back from the towbar when chipping as it helps reduce the dust . We chipped into a transit tipper with high sides and no roof the other week loads less dust

[Billy]

interesting, why does that happen, was the tarp loose?

[White Noise]

Its only a small chip box ? but when firing the chip into an unvented box the dust can only escape one way out . Not the chip only the small dust particles .

Maybe a half covered box would be better .